Setup
LAN Cable Connection
Connect the camera to a hub or computer using a LAN cable.
When connecting to a hub
Make use of a straight cable.
When connecting to a computer
Make use of a Cross Over cable.
LAN cable
Alarm Input/Output Cable Connection
Connect the alarm input/output cables with external devices such as a sensor, buzzer, etc.
Signal name | Cable color |
|
|
Alarm input 1 | Pink |
|
|
Alarm input 2 | Blue |
|
|
Alarm output 1 | Orange |
|
|
Alarm output 2 | Yellow |
|
|
GND | Brown |
|
|
Cable to use
●Length of 50 m or shorter
●UL1007, UL1015 or equivalent products
●AWG#22 - AWG#18 or equivalent products
Alarm input/output cables
Solder or crimp
Wind the |
| |
waterproof | Insulation tape | |
tape. | ||
|
Note：
●Cross cables cannot be used with some computer models. When connecting VN- C215V4U directly to a computer, make sure to check the computer’s LAN specifications in advance.
Memo：
●Make use of a Category 5 (or higher) cable in the case of
Note：
●Noises from an external source may cause malfunctions even when the cable used is shorter than 50 m. In this case, use a shielded cable or move the cable away from the noise source.
26