JVC GR-DVL9800 specifications 16 EN, Basic Recording For Video, To Stop Recording

16EN

RECORDING

BasicRecordingForVideo

Shooting Mode Dial Power Switch NOTE:

PS	Power lamp
VIDEO
DUAL
VGA
XGA
	OFF
	Y
	A
	L
	P	D
	Y
	ALP CS
	Lock Button
	Recording
	Start/Stop Button

2 5 Display

Tape remaining time indicator (Approximate)

min 90 min 89 min 3 min

(Now calculating)

0 min 1 min 2 min

(Blinking) (Blinking) (Blinking)

Tally lamp

(lights while recording is in progress)

You should already have performed the procedures listed below. If not, do so before continuing.

●Power (☞ pg. 6)

●Grip Adjustment (☞ pg. 8)

●Viewfinder Adjustment (☞ pg. 8)

●Load A Cassette (☞ pg. 10)

●Recording Mode Setting (☞ pg. 11)

1 Set the Shooting Mode Dial to “VIDEO”, then set the Power Switch to “” or “ ” while pressing down the Lock Button located on the switch.

Shooting while using the viewfinder: Make sure the LCD monitor is closed and locked. Pull out the viewfinder fully.

•Be sure to pull out the viewfinder until you hear a click, otherwise it may be pushed back in during use.

Shooting while using the LCD monitor: Make sure the viewfinder is pushed back in. Press PUSH-OPENand open the LCD monitor fully. Tilt it upward/ downward for best viewability.

•The power lamp lights and the camcorder enters the Record-Standby mode. “PAUSE” is displayed.

Press the Recording Start/Stop Button. “	” appears
2 while recording is in progress.

To Stop Recording . . .

.... press the Recording Start/Stop Button. The camcorder

re-enters the Record-Standby mode.

MENU/

BRIGHT Wheel

BR I GHT – +

180° 90°

PUSH

To Adjust The Brightness Of The Display

.... rotate MENU/BRIGHT until the bright level indicator

on the display moves and the appropriate brightness is reached.

•It is also possible to adjust the brightness of the view- finder.

PUSH-OPEN Button