JVC GR-DVL9800 specifications EN83

EN83

SYMPTOM	POSSIBLE CAUSES
27. When shooting a subject	27. •This is a result of exceed-
illuminated by bright light,	ingly high contrast, and is
vertical lines appear.	not a malfunction.
28. When the screen is under	28. •This is not a malfunction.
direct sunlight during
shooting, the screen
becomes red or black for
an instant.
29. During recording, the date/	29. •“DATE/TIME” is set to
time does not appear.	“OFF” in the Menu Screen.
	•Interface Shooting is
	performed.
30. Images stored in the	30. •Images stored in the
MultiMediaCard cannot be	MultiMediaCard are
deleted.	protected.
31. The indicators and	31. •“ON SCREEN” is set to
messages do not appear.	“SIMPLE” or “TIME CODE”
	is set to “OFF” in the Menu
	Screen.
32. Images on the LCD	32. •In places subject to low
monitor appear dark or	temperature, images become
whitish.	dark due to the characteristics
	of the LCD monitor. When
	this happens, the displayed
	colours differ from those that
	are actually recorded. This is
	not a defect of the camcorder.
	•When the LCD monitor's
	fluorescent light reaches the
	end of its service life,
	images on the LCD monitor
	become dark. Consult your
	nearest JVC dealer.
33. The rear of the LCD	33. •The light used to illuminate
monitor is hot.	the LCD monitor causes it to
	become hot.
34. The indicators and the	34. •This may occur when the
image colour on the LCD	surface or the edge of the
monitor are not clear.	LCD monitor is pressed.
35. The LCD monitor or	35. •Certain Fade/Wipe effects,
viewfinder indications	certain modes of Programme
blink.	AE with special effects, “DIS”
	and other functions that
	cannot be used together are
	selected at the same time.

CORRECTIVE ACTION

27.

————

28.

————

29.•Set “DATE/TIME” to “ON”

in the Menu Screen (☞ pg. 33).

•During Interface Shooting, the date/time does not appear (☞ pg. 17).

30.•Remove protection from the images stored in the

MultiMediaCard and delete them (☞ pg. 50, 51).

31.•Set “ON SCREEN” to “LCD” or “LCD/TV” and set “TIME

CODE” to “ON” in the Menu Screen (☞ pg. 33, 46).

32.•Adjust the brightness and

angle of the LCD monitor (☞ pg. 16, 17).

33.•Close the LCD monitor to turn it off or set the Power Switch to “OFF”, and let the unit cool down.

34.

————

35.•Re-read the sections covering Fade/Wipe effects, Programme AE with special

effects and “DIS”

(☞ pg. 32, 38 – 41).

CONTINUED ON NEXT PAGE