JVC GR-DVL9800 specifications 66 EN, Dubbing Images Stored In a MultiMediaCard To a Tape

66EN

DUBBING(cont.)

Dubbing Images Stored In A

MultiMediaCard To A Tape

Images can be dubbed from a MultiMediaCard to a tape.

1 Load a MultiMediaCard (☞ pg. 12) and cassette (☞ pg. 10).

Power Switch

			AY PL	A
		L
		P		Y
S	C				OFF
D

Lock Button

Recording Start/

Stop Button

Rewind Button (2)
Fast-Forward Button (3)
Display
SP	– – –
TO COPY TO TAPE
PUSH S TART / S TOP

SP 444

2 Set the Power Switch to “ ” while pressing down the Lock Button located on the switch. Open the LCD monitor fully or pull out the viewfinder fully.

3 To locate the point where you wish to dub a still

2

image, play back the tape. Stop playback at the desired point.

4 Set the Power Switch to “ ” while pressing

3

down the Lock Button located on the switch.

To select a still image to be dubbed, perform Index Playback (☞ pg. 49), Auto Playback (☞ pg. 48) or press 2or 3to select the image you wish.

5 To engage Dub-Standby, press the Recording Start/ Stop Button. The message “TO COPY TO TAPE PUSH START/STOP” appears.

6 While the message is being displayed, press the Recording Start/Stop Button. The selected still image is recorded on the tape for approx. 6 seconds. •The “SP” or “LP” and tape running indicators

disappear when dubbing is complete.

NOTES:

●If the Recording Start/Stop Button is pressed in step 5 when the tape’s erase protection tab is set to “SAVE”, the message “COPYING FAILED” is displayed.

●The XGA image is dubbed onto the tape at 720 x 640 pixels.

●You can superimpose a print frame over the selected still image to be dubbed (☞ pg. 52) and dub it to a tape. After step 4, superimpose a print frame over the still image and go to step 5.