JVC GR-DVL9800 specifications Advanced Features For Video And D.S.C, Dual Shooting, Focus Button

26ENRECORDING

AdvancedFeaturesForVideoAndD.S.C.(cont.)

Power Switch Dual Shooting

SNAPSHOT Button

Video image

Still image

OFF

Y

A

L

P

Y	D
ALP CS

Lock Button

SNAPSHOT Button

Released position

Half-pressed

position

Fully-pressed

position

Lets you record images on a tape and store still images in a MultiMediaCard simultaneously. In other words, it is possible to store still images in the MultiMediaCard without interrupting image recording on the tape.

1 Set the Shooting Mode Dial to “DUAL”, then set the Power Switch to “” or “ ” while pressing down the Lock Button located on the switch. Pull out the viewfinder fully or open the LCD monitor fully.

2 While recording to a tape, press SNAPSHOT halfway. A still image is displayed in the lower right corner of the screen where the video image being recorded is displayed.

•At this moment, if you release SNAPSHOT, snapshot recording will be cancelled.

3 Press SNAPSHOT fully. The displayed still image is stored in the MultiMediaCard.

NOTES:

●If SNAPSHOT is pressed in the Record-Standby mode, only a still image is stored in the MultiMediaCard. Video recording does not take place.

●If SNAPSHOT is pressed when “DIS” is set to “ON” (☞ pg. 32), the Stabiliser will be disabled.

●The Stabiliser is less effective in the DUAL mode than in other modes.

●The flash is disabled during video recording.

●Still images are stored in the MultiMediaCard in VGA mode file size (☞ pg. 15).

●When the Shooting Mode Dial is set to “DUAL”, all

Fade/Wipe Effects and some Programme AE with special effects cannot be used (☞ pg. 38 – 41).

Shooting Mode Dial

PS

VIDEO

DUAL

VGA

XGA

FOCUS Button (5)