Bosch Appliances 5000 IP installation manual Multicast, Rtsp port, UPnP, TCP Metadata

110 en Advanced Mode DINION capture 5000 IP

RTSP port

If necessary, select a different port from the list for the exchange of the RTSP data. The standard RTSP port is 554. Select Off to deactivate the RTSP function.

UPnP

Select On to activate UPnP communication. Select Off to deactivate it.

When UPnP is activated the camera reacts to requests from the network and is registered automatically as a new network device on the inquiring computers.

Note:

To use the UPnP function on a computer with Windows XP or Windows Vista, the Universal Plug and Play Device Host and the SSDP Discovery services must be activated.

This function should not be used in large installations due to the large number of registration notifications.

TCP Metadata

The device can receive data from an external TCP sender, for example an ATM or POS device, and store it as metadata. Select the port for TCP communication. Select Off to deactivate the function. Enter a valid Sender IP address.

8.8.3Multicast

In addition to a one-to-one connection between a camera and a single receiver (unicast), the camera can enable multiple receivers to receive the video signal simultaneously. This is either done by duplicating the data stream in the device and then distributing it to multiple receivers (multi-unicast), or by distributing an individual data stream in the network itself to multiple receivers in a defined group (multicast). Enter a dedicated multicast address and port for each stream. Then switch between the streams by clicking the associated tabs. The prerequisite for multicast operation is a multicast-capable network that uses the UDP and IGMP protocols. Other group membership protocols are not supported. The TCP protocol does not support multicast connections.

1.0 2012.01 Installation Manual Bosch Security Systems, Inc.