DINION capture 5000 IP | Safety en | 9 |
|
|
|
8.Power disconnect - Units have power supplied to the unit whenever the power cord is inserted into the power source. The power cord plug is the main power disconnect device for switching off the voltage for all units.
9.Power sources - Operate the unit only from the type of power source indicated on the label. Before proceeding, be sure to disconnect the power from the cable to be installed into the unit.
–For external power supplied units, use only the recommended or approved power supplies.
–For limited power source units, this power source must comply with EN60950. Substitutions may damage the unit or cause fire or shock.
–For 24 VAC units, voltage applied to the unit's power input should not exceed ±10%, or 26.4 VAC. User- supplied wiring must comply with local electrical codes (Class 2 power levels). Do not ground the supply at the terminals or at the unit's power supply terminals.
–If unsure of the type of power supply to use, contact your dealer or local power company.
10.Servicing - Do not attempt to service this unit yourself.
11.Damage requiring service - Unplug the unit from the main AC power source and refer servicing to qualified service personnel when any damage to the equipment has occurred, such as:
–the power supply cord or plug is damaged;
–internal exposure to moisture, water, and/or inclement weather (rain, snow, etc.);
–liquid has been spilled in the equipment;
–an object has fallen into the unit;
–unit has been dropped;
–unit exhibits a distinct change in performance;
–unit does not operate normally when the user correctly follows the operating instructions.
Bosch Security Systems, Inc. | Installation Manual | 1.0 2012.01 |