Panasonic AW-E800 manual GEN-LOCK Adjustment, Horizontal Phase Control

■GEN-LOCK ADJUSTMENT

Phase adjustments must be performed with the camera or the RCU (RCB) when external synchronizing signals are supplied to the system in cases where multiple cameras are used or peripheral devices are connected.

●HORIZONTAL PHASE CONTROL

Observe the waveform of the external synchronizing input signal (black burst signal) and video output signal on a two-channel oscilloscope. Then match the hori- zontal phase of both signals by adjusting them with the

**G/L, @Color Bar Set**
H Phase		± 0
SC	Coarse	1
SC	Fine	± 0
Color Bar Set		7.5IRE

Return

OPTION CARD	VIDEO OUT
MENU	I/F REMOTE

ITEM/AWC	G/L IN
YES/ABC
	IRIS
NO/BAR
	DC12V IN
NO/BAR switch
YES/ABC switch

cameras or RCU's horizontal phase control.

External gen-lock input signal (black burst output of special effect generator)

Video signal

Adjust the horizontal phase

[ADJUSTMENT by CAMERA]

1.Press the NO/BAR switch for over 5 seconds to dis- play the color bar.

2.Select [G/L Adjustment] on the main menu, then select [H PHASE] on the submenu.

3.Adjust the horizontal phase with the YES/ABC and NO/BAR switch.

[ADJUSTMENT with RCU (RCB, Hybrid control panel )] Use the horizontal phase control.

	ENC		OFF
					PAGE	ITEM		UP		DOWN
	VF			ON				SC PHASE
	USER SET					COARSE				FINE
		H.PHASE				0°	270°
						90°	180°
Horizontal phase
									Subcarrier phase
control									fine control

Subcarrier phase coarse control

-25-