Axis Communications 215 PTZ-E manual Installing the network camera, Wall mount, Ceiling mount

AXIS 215 PTZ-E Installation Guide Page 5

Installing the network camera

There are two ways of mounting the camera - wall mount and ceiling mount. Follow the appropriate instructions below.

Note:

Use protective covers for the cables that are in compliance with the IP-66 rated, outdoor-proof design of the AXIS 215 PTZ-E.

Wall mount

1.Using the provided drill template, drill four holes in the wall.

2.Place the AXIS 215 PTZ-E network camera to the wall and attach it using four screws appropriate to the wall material.

Ceiling mount

The AXIS 215 PTZ-E is shipped with an NPT adaptor. See www.axis.com for a list	Wall
	bracket
of available mounting brackets.

1.Remove the wall bracket by taking off the four screws attached to it, using the 5mm allen key provided.

2.Remove the sunshield (optional) by taking off the three screws attached to it, using the 5mm allen key provided.

ENGLISH

3.Attach the supplied NPT adaptor onto a pole mount bracket.

4.Attach the AXIS 215 PTZ-E network camera to the NPT adaptor using the four large screws.

Pole mount bracket

(1.5 inch)

o-ring

NPT adaptor

o-ring

Connecting the cables

1.Connect the 5m CAT5E network cable to the network.

2.Connect the 5m power cable to a 100-240VAC, 1.2A, 50/60Hz power connector, according to the following table:

Input100-240 VAC

L	N	GND
brown	blue	yellow-green

Warning - High voltage! The electrical connection should be made by an authorized electrician. Please observe relevant national and local regulations for the installation.