Samsung SCC-C6475(P) manual Initial Setting, Setting RS-422A/RS-485 termination, Baud Rate Setting

INITIAL SETTING

CAMERA ADDRESS SETUP

Use SW701, SW702, or 703 for Camera Address setup. You may allocate up to 255 addresses by using SW701 to set the 3rd digit, SW702 the 2nd digit, and SW703 the 1st digit.

EX) In case of Camera Address 1, see the following figure for setup.

SW701SW702SW703

Setting communication Protocol

Use number 1~4 PIN of SW704 to set communication Protocol.

Setting RS-422A/RS-485 termination

	1	2
As it is shown in the structure map, when Controller and RS-422A/RS-
485 is connected it should be terminated according to the Cable feature
					E
of impedance on the each end of the transmitting line to transfer the
signals in long distance by controlling the reflection of the signals to the
lowest.
			Division	n < 32

PIN	PIN1	PIN2	PIN3	PIN4
Comp
A	OFF	OFF	OFF	OFF
B	ON	OFF	OFF	OFF
C	OFF	ON	OFF	OFF
D	ON	ON	OFF	OFF
E	OFF	OFF	ON	OFF
F	ON	OFF	ON	OFF
G	OFF	ON	ON	OFF
H	ON	ON	ON	OFF
I	OFF	OFF	OFF	ON
J	ON	OFF	OFF	ON
K	OFF	ON	OFF	ON
L	ON	ON	OFF	ON
M	OFF	OFF	ON	ON

A : SAMSUNG HALF

B : SAMSUNG FULL

SEE INSTRUCTION MANUAL

ON 1 2 3 4 5 6 7 8

SW704

(x100) (x10) (x1)

SW701 SW702 SW703

Termination

SW1-ON

<RS-485 Half Duplex Organization>

Termination: using numbers 1 and 2 PIN, turn to ON and it will be terminated.

n < 32

N	ON	OFF	ON	ON
O	OFF	ON	ON	ON
P	ON	ON	ON	ON

(BOTTOM VIEW)

Division

Division SW1-ON SW2-ON

Baud Rate Setting

Use PIN 5 and 6 of SW704.

1		2	3	4	5	6	7	8
ON
OFF
			SW 704
	BAUD RATE								PIN 5	PIN 6
	4800 BPS								ON	ON
	9600 BPS								OFF	ON
	19200 BPS								ON	OFF
	38400 BPS								OFF	OFF

1-11

<RS-422A/RS-485 Full Duplex Organization>

1-12