5 Select one from “P.1” through “P.6” by rotating the [Rotary encoder], and press the [Rotary encoder].
The data is stored in the selected preset number.
•The function is operable when Defeat is set to OFF.
•The stored contents are not deleted even when resetting the unit or disconnecting the battery.
Recalling a Stored Setting (Preset Call)
The preset memory stores various setting/adjustment information. Thus, it takes some time to call data from the preset memory.
1 Press and hold [VIEW] for at least 2 seconds.
2 Select a preset from “P.1” through “P.6” by rotating the [Rotary encoder], and press the [Rotary encoder].
The values of the selected preset number are retrieved.
•You can call the Preset even by the following procedure: 1 Press [FUNC.].
2 Rotate the [Rotary encoder] to select “Preset, ” and then press the [Rotary encoder].
3 Rotate the [Rotary encoder] to select “Call,” and then press the [Rotary encoder].
4 Select a preset from “P.1” through “P.6” by rotating the [Rotary encoder], and press the [Rotary encoder].
The values of the selected preset number are retrieved.
•The function is operable when Defeat is set to OFF.
•If the speaker system in the preset and the current speaker system do not match, the preset cannot be retrieved.
•If the AUX input system in the preset and the current AUX input system do not match, the items concerning the AUX input system are unavailable for retrieval.
Setting the Speaker System (System Select)
First, set the system and the speakers. Unless you set the system, you cannot set any features. Be sure to set the system first. If the selected system and the connections of the speakers do not match, the speakers may be damaged. Make sure to check the connections of the speakers before selecting the system.
From the Commander
Only for the initial startup:
1 Press the [FUNC.] or [Rotary encoder].
The Output System selection screen is displayed. Go to Step 3.
1 Press [FUNC.].
2 Rotate the [Rotary encoder] to select “Output Setup,” and then press the [Rotary encoder].
3 Rotate the [Rotary encoder] to select “System Select,” and then press the [Rotary encoder].
The Output System selection screen is displayed.
4 Rotate the [Rotary encoder] to select a system, and then press the [Rotary encoder].
4.2ch system | |
| (Front2Way+Rear+Subwoofer) |
2.2ch system (Front3Way+Subwoofer) | |
4.0ch system (Front3Way+Rear) |
•Refer to Table 1 (Output System) in “System Configuration” (page 60).
5 Select “OK” by rotating the [Rotary encoder] when a confirmation message appears, and press the [Rotary encoder].
The Speaker Setup screen is displayed.
•When “OK” is selected, the audio output is stopped until the ignition key is turned on/off.
6 Turn off any unconnected speakers. Rotate the [Rotary encoder] to select “ON” or “OFF,” etc., and then press the [Rotary encoder].
Repeat the steps until all the speakers are set.
FRONT HIGH*1: OFF/Tweeter/Full
FRONT LOW: OFF/ON
REAR:OFF/ON
CENTER: OFF/ON
SUBWOOFER(1, 2): OFF/ON
SW CHANNEL: Mono/Stereo*2