5 When the setting is complete, press and hold [ 
] for at least 2 seconds.
•If [ 
] is pressed during setting, the unit returns to the previous item.
•This feature is effective only for Dolby Digital.
•Use this feature at a volume level at which you can still hear sound outside of the cabin.
•Depending on the types of source, such as DVD software, this feature may be ineffective.
•After the setting, it is recommended to store the setting contents on the unit. For details, refer to “Storing the Preset Values (Preset Store)” (page 36).
Adjusting the DVD Level (DVD Level)
The volume level for Dolby Digital, Dolby PLII, DTS, EUPHONY and PCM modes can be set. (Initial setting: “±0dB”)
1 Press [FUNC.].
2 Rotate the [Rotary encoder] to select “Multi Ch. Setup,” and then press the [Rotary encoder].
3 Rotate the [Rotary encoder] to select “DVD Level,” and then press the [Rotary encoder].
4 Select the mode you want to adjust by rotating the [Rotary encoder], and press the [Rotary encoder].
Adjustment modes: Dolby D/Dolby PLII/DTS/PCM/
EUPHONY
5 Select the level by rotating the [Rotary encoder].
Adjustment level:
6 Press [ 
]. Repeat Steps 4 and 5 to set the levels for each mode.
7 When the setting is complete, press and hold [ 
] for at least 2 seconds.
•If [ 
] is pressed during setting, the unit returns to the previous item.
•Avoid stopping, pausing, switching the disc, cueing,
•After the setting, it is recommended to store the setting contents on the unit. For details, refer to “Storing the Preset Values (Preset Store)” (page 36).
From the Commander
Other Useful
Features
FUNC. | BLACK OUT indicator |
|
|
|
|
|
|
|
|
VIEW | MUTE | ||
|
|
|
|
Rotary encoder
Lowering Volume Quickly (Mute)
Activating this function will instantly lower the volume level by 20 dB.
1 Press [MUTE].
The audio level decreases by about 20 dB.
2 To cancel muting, press [MUTE] again.
•Either switch will cancel muting.
•When an
Turning the Back Light Off (BLACK OUT function)
When Blackout Mode is turned on, the backlight and illuminated buttons of the Commander display and the
1 Press and hold the [Rotary encoder] for at least 2 seconds.
The backlight is turned off. The BLACK OUT indicator will turn on.
2 To cancel this, press and hold the [Rotary encoder] again for at least 2 seconds.
•When another switch is operated while the backlight is off, the illumination backlight for the display is turned on for 5 seconds and then turned off again.