•The optional expansion box
•REAR 1/REAR 2 can be set when “Setting the External Rear Monitor Output” (page 9) is turned on.
•If the source of REAR 1/REAR 2 is set to NAVIGATION, though the source name of the rear monitor is displayed as DVD, the navigation screen is output.
Switching the function of the remote sensor
The remote sensor of the external monitor can be switched, as you prefer.
1 Press 8 or 9 on the SETUP screen and select REMOTE CONTROL SEL.
2 Press gor fand select a monitor using the remote control.
The monitor which has a priority to the remote control operation is changed.
FRONT: The remote control eye of this unit is effective.
3 To finish the setting, press and hold MUTE for at least 2 seconds.
•
•If
Setup
8
g f
9
MUTE
Setup Operation
To display the SETUP mode screen:
To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below.
1.Bring your vehicle to a complete stop at a safe location. Engage the parking brake.
2.Keep pushing the foot brake and release the parking brake once then engage it again.
3.When the parking brake is engaged for the second time, release the foot brake.
•For automatic transmission vehicles, place the transmission lever in the Park position.
Now, the locking system for the SETUP operation has been released. Engaging the parking brake can reactivate the SETUP mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3), of “To display the SETUP mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To display the SETUP mode screen.”
The following steps 1 to 4 are common operations to each “Setting item” of Setup. Refer to each section for details.
1 Press and hold MUTE for at least 2 seconds.
The SETUP screen is displayed.
2 Select the desired setting item by pressing either 8 or 9.
Continued