Panasonic DMW-MCTZ3 operating instructions Check the O-ring, Inspect the O-ring groove, 3Sand

2 Check the O-ring.

≥Check that there is no dirt, sand, hair, dust, salt crystals, lint or grease on the O-ring. If you find any of these, remove them with a soft, dry cloth.

3Dirt 3Sand 3Hair 3Dust

3Salt crystals 3Lint

≥There may be dirt on the O-ring that you cannot see. Check if there is any dirt by rubbing your finger over the O-ring.

≥Be careful not to leave any fibers from the dry cloth on the O-ring when wiping it.

≥Check that the O-ring is not ripped, twisted, squashed, frayed or scratched and that there is no sand sticking to it. Replace the O-ring in these cases.

3Ripped

3Scratched

3Twisted 3Squashed 3Frayed

3Sand sticking

3 Inspect the O-ring groove.

≥Grains of sand or hardened salt crystals may get into the O-ring groove. Remove them carefully with an air spray or a cotton swab. If you use a cotton swab, be careful not to leave any fibers from it in the O-ring groove.

11

VQT1F25