NordicTrack NCTL15991 user manual You, If you, Cline will, Cally

Current Segment

	Press the Start Program button or the Speed	▲
5
	button to start the program.

A moment after the button is pressed, the tread- mill will automatically adjust to the first speed and incline settings for the program. Hold the handrails and begin walking.

Each program is divided into several time segments of different lengths. The Time display will show both the time remaining in the program and the time remaining in the current segment. One target heart rate setting

is programmed for each segment.

The heart rate set- ting for the first segment will be shown in the flash- ing Current

Segment column of the program display. The heart rate settings for the next twelve segments will be shown in the twelve columns to the right.

When only three seconds remain in the first seg- ment of the program, both the Current Segment column and the column to the right will flash, a se- ries of tones will sound, and all heart rate settings will move one column to the left. The heart rate setting for the second segment will then be shown in the flashing Current Segment column. As you exercise, the speed and/or incline of the treadmill will automatically change as needed to keep your heart rate near the current target heart rate setting.

The program will continue until no time remains in the Time display. The walking belt will then slow to a stop.

If the speed or incline setting for the current seg- ment is too high or too low, you can adjust the set-

ting with the Speed or Incline buttons. However, if
you	decrease		the speed, the incline will automati-
cally	increase		; if you		increase		the speed, the in-
cline will		decrease		. If you		increase		the incline, the
speed will			decrease	; if you			decrease	the incline,
the speed will			increase		. The treadmill will always
attempt to keep your heart rate near the target
heart rate setting for the current segment.								Note:

When the incline reaches the lowest setting, the speed cannot be increased any further. When the incline reaches the highest setting, the speed can- not be decreased any further.

If your heart rate is not detected during the pro- gram, the speed and incline of the treadmill may automatically decrease until your heart rate is detected. If this occurs, refer to the instructions in- cluded with the optional chest pulse sensor.

Pulse-driven programs should not be stopped temporarily and then restarted. To end the pro- gram at any time, press the Stop button, remove the key, and then reinsert the key.

6 Follow your progress with the displays. Refer to step 5 on page 11.

7 When the program has ended, remove the key.

See step 6 on page 13.

18