Gold's Gym GGTL78609.0 manual Troubleshooting, Problem The power turns off during use

Page 25

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 13). Use only a single-outlet surge suppres- sor that meets all of the specifications described on page 13. IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c. Check the reset/off circuit breaker located on the

c

 

treadmill frame near the power cord. If the switch

 

protrudes as shown, the circuit breaker has

Tripped

Reset

tripped. To reset the circuit breaker, wait for five

minutes and then press the switch back in.

 

 

PROBLEM: The power turns off during use

 

 

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The console displays remain lit when you remove the key from the console

SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a

store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off

the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE

INFORMATION MODE on page 21 to turn off the demo mode.

 

 

PROBLEM: The displays of the console do not function properly

 

 

 

SOLUTION: a. Remove the key from the console and UNPLUG

a

85

 

THE POWER CORD. With the help of a second

 

person, carefully tip down the Uprights (85, 86).

 

 

 

There may be two #12 x 2" Screws (14) in the bot-

 

 

 

tom of the Belly Pan (79). If there are, remove

 

 

 

them. Note: A Phillips screwdriver with a shaft at

86

 

 

least 5 in. (13 cm) long is required. Raise the

 

 

Uprights to a vertical position.

 

 

14

 

 

79

 

 

 

 

 

14

 

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Model No. GGTL78609.0 Serial No QUESTIONS?Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Pulse sensor is not a medical device Important PrecautionsPage Before YOU Begin Do not fully fold the Frame yet AssemblySpacer 92. Be careful not to pinch Upright Wire Ful not to pinch the Upright WireTighten the Nut the Wheel must turn freely Not fully tighten the Bolts yetWheel must turn freely No wires are pinched. Do not fully tighten Bar. See the inset drawing. The connectorsConsole assembly. See the inset drawing Should slide together easily and snap intoUprights. Be careful not to pinch any wires 108 Next, hold the receiver so that the antenna is HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerInsert the key into the console Distance Follow your progress with the displays. The matrix-When youTurn on the fans if desired Select a preset workout HOW to USE a Preset WorkoutStart the workout Select a custom workout HOW to Create a Custom WorkoutHOW to USE a Custom Workout Insert an iFit card and select a workout HOW to USE AN Ifit WorkoutHOW to USE the Stereo Sound System Information ModeMake sure that the audio wire is fully plugged Optional Chest Pulse Sensor HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingTop Problem The walking belt slows when walked onProblem Solution Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyKey No. Qty Description Part LIST-Model No. GGTL78609.0Qty Exploded Drawing A-Model No. GGTL78609.0 R0709A Exploded Drawing B-Model No. GGTL78609.0 R0709A Exploded Drawing C-Model No. GGTL78609.0 R0709A 10 101 100 104 124 102 103 105 106 107 108 122 Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents