Gold's Gym GGTL78609.0 manual Tighten the Nut the Wheel must turn freely

2.	Attach a Wheel (96) to the Base (95) with a 3/8"	2
	x 2" Bolt (5) and a 3/8" Nut (9). Do not over-
	tighten the Nut; the Wheel must turn freely.
	See the inset drawing. Cut the plastic tie near			95
	the Upright Wire (97).		5
				9	96	97Cut
3. Identify the Right Upright (86) and the Right		3
	Upright Spacer (92).				86
	Insert the Upright Wire (97) through the Right
	Upright Spacer (92) as shown. Then, set the
	Right Upright Spacer on the Base (95). Be care-		97
	ful not to pinch the Upright Wire.	Wire Tie					97
	Have a second person hold the Right Upright							92
	(86) near the Base (95). See the inset drawing.
	Tie the wire tie in the Right Upright securely						95
	around the end of the Upright Wire (97). Then,
	pull the other end of the wire tie until the Upright
	Wire is routed completely through the Right
	Upright.	97		86
				Wire
				Tie
4. Hold a Bolt Spacer (25) inside the lower end of		4
	the Right Upright (86). Next, insert a 3/8" x 4
	1/2" Bolt (6) with a 3/8" Star Washer (10) into		86			6
	the Right Upright and the Bolt Spacer. Repeat				92
	this step with a second Bolt Spacer (25), 3/8"
	x 4 1/2" Bolt (6), and 3/8" Star Washer (10).					10
	Then, set the Right Upright in the Right Upright
	Spacer (92). Be careful not to pinch the
	Upright Wire (97).						25
	Partially tighten the 3/8" x 4 1/2" Bolts (6); do					97
	not fully tighten the Bolts yet.
		7