Gold's Gym GGTL78609.0 manual

Page 4



20.	Never leave the treadmill unattended while it		24.	Inspect and properly tighten all parts of the
	is running. Always remove the key, unplug			treadmill regularly.
	cuit breaker to the off position when the		25. DANGER: Always unplug the power
	the power cord, and switch the reset/off cir-			cord immediately after use, before cleaning the
	treadmill is not in use. (See the drawing on
	page 5 for the location of the circuit breaker.)			treadmill, and before performing the mainte-
21.	Do not attempt to raise, lower, or move the			nance and adjustment procedures described in
				this manual. Never remove the motor hood un-
	treadmill until it is properly assembled. (See			less instructed to do so by an authorized ser-
	ASSEMBLY on page 6, and HOW TO FOLD			vice representative. Servicing other than the
	AND MOVE THE TREADMILL on page 23.)			procedures in this manual should be performed
	You must be able to safely lift 45 lbs. (20 kg)			by an authorized service representative only.
22.	to raise, lower, or move the treadmill.		26. This treadmill is intended for in-home use
	When folding or moving the treadmill, make			only. Do not use this treadmill in a commer-
	sure that the storage latch is holding the			cial, rental, or institutional setting.
23.	frame securely in the storage position.
	Never insert any object into any opening on
	the treadmill.	SAVE THESE INSTRUCTIONS

4

Image 4

Contents QUESTIONS? Model No. GGTL78609.0 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Pulse sensor is not a medical devicePage Before YOU Begin Assembly Do not fully fold the Frame yetFul not to pinch the Upright Wire Spacer 92. Be careful not to pinch Upright WireTighten the Nut the Wheel must turn freely Not fully tighten the Bolts yetWheel must turn freely Bar. See the inset drawing. The connectors No wires are pinched. Do not fully tightenConsole assembly. See the inset drawing Should slide together easily and snap intoUprights. Be careful not to pinch any wires 108 Next, hold the receiver so that the antenna is HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to USE the Manual Mode HOW to Turn on the PowerInsert the key into the console Distance Follow your progress with the displays. The matrix-When youTurn on the fans if desired Select a preset workout HOW to USE a Preset WorkoutStart the workout HOW to Create a Custom Workout Select a custom workoutHOW to USE a Custom Workout HOW to USE AN Ifit Workout Insert an iFit card and select a workoutHOW to USE the Stereo Sound System Information ModeMake sure that the audio wire is fully plugged Optional Chest Pulse Sensor HOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The walking belt slows when walked on TopProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. GGTL78609.0 Key No. Qty DescriptionQty Exploded Drawing A-Model No. GGTL78609.0 R0709A Exploded Drawing B-Model No. GGTL78609.0 R0709A Exploded Drawing C-Model No. GGTL78609.0 R0709A 10 101 100 104 124 102 103 105 106 107 108 122 Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT