Jabra GO 6470 user manual Configuring the Jabra GO Base for Your Desk Phone

4.5Configuring the Jabra GO Base for Your Desk Phone

When the touchscreen wizard is helping you set up your desk phone, it will ask you to call a Jabra test server. This enables the Jabra GO base to test its clear dial-tone-switch and microphone-level settings by exchanging signals with the test server.

Important: Your headset will not work correctly with your desk phone until you have set both the termination switch and microphone level as described in this section. You must repeat these procedures if you move the headset to a new type of desk phone.

Setting the Clear Dial-tone Switch to find a Clear Dial-tone

Follow the procedure below to find the best position for the clear dial-tone switch on the Jabra GO base; the correct position varies by desk phone model.

Figure 11: Setting the clear dial-tone switch manually

1.The touchscreen wizard prompts you to select either a manual or a guided setup, as shown in the figure below:

DESK PHONE

Do you prefer a guided

(recommended) or manual

Desk Phone setup?

Manual Guided

Figure 12: Manual or guided setup available

If you know exactly which clear dial-tone position and mic. level you need (you probably work in the IT dept.), you can select Manual. Otherwise, we strongly recommend you select Guided.

In the manual setup, the wizard prompts you first to select a clear dial-tone position and then a mic. level on the touchscreen. Neither one of your selections will be tested by the Jabra test server.

Note: For both the manual and guided setup procedures, you just need to follow the on-screen instructions.

Jabra GO 6470 User manual

20