Jabra GO 6470 user manual GN1000

CONNECT DESK PHONE	5. In the CON-	CONNECT	6. In the (second)
	NECT DESK		CONNECT
	PHONE		screen, shown
	screen, shown		left, connect
	left, connect		the control
	to the handset		cable attached
	port.		to the GN1000
			to the base’s
			AUX port.

Figure 21: Connect to the handset port Figure 22: Connect control cable to AUX port on the base

GN1000	7.	In the (first)
		GN1000
Mount and configure		screen, shown
GN1000 on desk phone.		left, mount

Follow the instructions in	and configure
	the GN1000
GN1000 manual
	on the desk
	phone.

GN1000

Did the GN1000 lift the handset successfully?

Yes No

8.In the (second)

GN1000 screen, shown left, you must determine whether the desk phone went off-hook. If so, touch Yes.

Figure 23: Mount and configure on the desk phone Figure 24: Touch Yes if the handset was lifted

If the handset was not lifted, touch No. In this case, you can choose to Retry or Cancel. If you choose to retry, the touchscreen takes you back to a point in this flow just after step1 (where Jabra GN1000 has been selected). If you choose to cancel, the setup is aborted and the touchscreen takes you to the start of the cabling procedure for configuration without EHS or GN1000. You can return to the GN1000 setup later.

GN1000	9.	In the (third)	GN1000	10. The (fourth)
		GN1000		GN1000 screen,
Check GN1000 manual to		screen, shown	Congratulations, GN1000	shown left,
adjust ring detector		left, check the	installation complete	lets you know
		GN1000 manual		that the setup
		to adjust the		is completed
		ring detector.		successfully. Just
				go to the next
				screen.

Figure 25: Adjust the ring detector Figure 26: A successful setup

The wizard now leads you through the clear dial-tone and mic. level configuration. See the section “Configuring the Jabra GO Base for your Desk Phone” for more.

Jabra GO 6470 User manual

24