Important information

Exiting the hibernate/idle state (S4 mode)

You switch on the system again either manually using the On/Off button or using the WOL function (WOL= Wake-up On LAN).

To do this, a Magic Packet with the MAC address of the system to be woken up is sent to the internal LAN controller.

You will find the valid MAC address for your device in the BIOS:

ÊDuring boot press [F2] to enter BIOS.

ÊNavigate to Main - System Information and press [Enter]. The MAC address is shown under Network Controller Details.

IAlternatively, you can find out the MAC address valid for your device using the command line tool IPCONFIG.

ÊOpen the command line tool using C:\Windows\System32\cmd.exe and enter the following command:

ipconfig /all

LINUX operating systems

Activation

ÊTo activate S4 mode, enter the following command: resume=/dev/sdxx

Using this command, the memory area in which the data is saved is assigned at the same time.

Execution

Using the following command, the system is switched off and brought into S4 mode:

echo -n "disk" > /sys/power/state

Exiting the hibernate/idle state (S4 mode)

You switch on the system again either manually using the On/Off button or using the WOL function (WOL= Wake-up On LAN).

To do this, a Magic Packet with the MAC address of the system to be woken up is sent to the internal LAN controller.

MX130 S2

Upgrade and Maintenance Manual

41

Page 41
Image 41
Fujitsu MX130 S2 manual Ipconfig /all Linux operating systems Activation