Basic software procedures

5.2.3Enabling Option ROM scan

In order to configure an expansion card that has been installed or replaced, the card’s Option ROM has to be enabled in the system board BIOS. The card’s firmware is called by the system BIOS upon reboot and can be entered and configured.

Option ROM can be enabled permanently (e.g. in case of a boot controller that may require frequent setup) or temporarily for one-time configuration.

When the enabled expansion card is initialized during the POST phase of the boot sequence, a key combination is displayed temporarily to enter the expansion card’s firmware.

ÊPress the displayed key combination.

ÊModify the expansion card firmware options as desired.

ÊSave your changes and exit the firmware.

As default setting for this system, Option ROM is enabled for all onboard controllers and all expansion card slots.

For detailed information on how to access the BIOS and modify settings, refer to the "D3090/D3091 BIOS Manual".

5.2.4Verifying and configuring the backup software solution

IThis task only applies to the Japanese market.

Disabling backup drives

Depending on the backup software solution, it may be necessary to disable or delete the backup drive from the backup software drive list and reconfigure backup jobs after completing the maintenance task.

This is the case for the following backup software solutions:

Netvault for Windows

ARCServe

BackupExec

64

Upgrade and Maintenance Manual

MX130 S2

Page 64
Image 64
Fujitsu MX130 S2 manual Enabling Option ROM scan, Disabling backup drives