Basic software procedures
5.2.7Performing a RAID array rebuild
After replacing a hard disk drive that has been combined into a RAID array, RAID rebuild will be performed completely unattended as a background process.
Figure 14: Progress bar (RAID array rebuild)
VCAUTION!
The system is now operational, however, data redundancy will not be available until the RAID array rebuild is complete. Depending on the hard disk drive capacity the overall process can take up to several hours, in some cases even days.
IYou may notice a slight performance impact during rebuild.
5.2.8Looking up changed MAC addresses
When replacing the system board, the MAC (Media Access Control) address will change. In order to look up changed MAC adresses, proceed as follows:
ÊEnter the BIOS.
ÊIn the Main menu, select System Information and press [Enter].
ÊNote down the new
ÊPress [Esc] to exit the System Information menu.
ÊPress [Esc] to exit the BIOS.
ÊInform the customer about the changed MAC address.
MX130 S2 | Upgrade and Maintenance Manual | 67 |
