Fujitsu MX130 S2 manual Replacing the processor, Concluding steps

Processors

ÊFasten the four captive screws on the heat sink (screw torque: 0.6 Nm, not applicable for the Japanese market).

ÊConnect the CPU fan cable to the system board connector FAN1.

11.2.6 Concluding steps

Perform the following procedures to complete the task:

ÊFollow all procedures described in section "Closing the server" on page 54.

11.3Replacing the processor

Field Replaceable Units (FRU)

Average hardware task duration: 15 minutes

Average software task duration: 5 minutes

VCAUTION!

Processors are extremely sensitive to electrostatic discharge and must be handled with care. After a processor has been removed from its protective sleeve or from its socket, place it upside down on a nonconducting, antistatic surface. Never push a processor over a surface.

11.3.1 Required tools

●Preliminary and concluding steps: tool-less

●Removing and installing the processor heat sink:

– Phillips PH2 / (+) No. 2 screw driver

●Removing and installing the processor: tool-less

MX130 S2 Upgrade and Maintenance Manual 191