Expansion cards

9.2.1.5Connecting cables to the expansion card

ÊIf applicable, connect internal cables to the expansion card.

IFor a complete cabling overview, please refer to section "Cabling" on page 235.

9.2.1.6Concluding steps

Perform the following procedures to complete the task:

ÊFollow all procedures described in section "Closing the server" on page 54.

ÊAfter installing or replacing a Modular RAID controller, update the firmware as described in section "Updating RAID controller firmware" on page 63.

ÊIn order to configure an expansion card that has been installed or replaced, the card’s Option ROM has to be enabled in the system board BIOS. If applicable, proceed as described in section "Enabling Option ROM scan" on page 64.

ÊIf the new expansion card replaces a previously installed network adapter, inform the customer about changed MAC addresses. For further information, refer to section "Looking up changed MAC addresses" on page 67.

ÊIf BitLocker functionality is used and has been disabled before starting the maintenance task, re-enable BitLocker as described in section "Enabling BitLocker functionality" on page 66.

9.2.2Removing expansion cards

Upgrade and Repair Units (URU)

Average task duration: 5 minutes

9.2.2.1Required tools

Preliminary and concluding steps: tool-less

Removing expansion cards: tool-less

MX130 S2

Upgrade and Maintenance Manual

165

Page 165
Image 165
Fujitsu MX130 S2 manual Removing expansion cards, Expansion cards Connecting cables to the expansion card