JVC CA-MXJ200 To turn on On the remote control, Put a recordable cassette into deck B Press Shift

English

4	Set the on-time you want the unit	– PRESET +
	to turn on.

On the remote control:

1)Press 4or ¢ to set the hour, then press SET.

2)Press 4or ¢ to set the minute, then press SET.

“OFF TIME” appears for 2 seconds, then the unit enters off-time setting mode.

SET

1	Put a recordable cassette into deck B.
2	Press SHIFT.	SHIFT
3	Press TIMER until “REC” appears	TIMER

5 Set the off-time you want the unit to turn off (on standby).

1)Press 4or ¢ to set the hour, then press SET.

2)Press 4or ¢ to set the minute, then press SET.

The unit enters preset station selecting mode.

–PRESET +

SET

on the display. 2

REC

The REC indicator also starts flashing on the display.

•Each time you press the button, the timer setting mode changes as follows:

6 Select the preset station. – PRESET +

1) Press 4or ¢ to select the band (“TUNER FM” or “TUNER AM”), then press SET.

2)Press 4or ¢ to select a preset channel number, then press SET.

The REC indicator stops flashing and	SET
remains lit. The settings you have done are
shown on the display in sequence.

7 Press	(standby/on) to turn off the	STANDBY
unit (on standby) if necessary.

If you want to listen to another source while recording

Press REC START/STOP to stop recording. Without stopping it, you cannot change the source.

DAILY = ON TIME = REC = ON TIME = Clock setting (See page 11.) = Canceled

4 Press TIMER again.	TIMER
“ON TIME” appears for 2 seconds, then the	2
unit enters on-time setting mode.

REC

REC

To turn on or off Recording Timer after its setting is done

5 Set the on-time you want the unit

– SELECT +

1	Press CLOCK/TIMER repeatedly until
	“REC” appears on the display.
2	To turn off the Recording Timer, press
	CANCEL (on the unit only).
	The REC indicator goes off and “OFF” appears
	on the display.
	The Recording Timer is canceled, but the setting

CLOCK/TIMER

DEMO

CANCEL

to turn on.

1)Press SELECT – or SELECT + to set the hour, then press SET.

2)Press SELECT – or SELECT + to set the minute, then press SET.

“OFF TIME” appears for 2 seconds, then the unit enters off-time setting mode.

4 5

SET

8

for the Recording Timer remains in memory.

To turn on the Recording Timer, press SET.

The REC indicator lights up on the display. The

settings you have done are shown on the display

in sequence for your confirmation.

SET

6 Set the off-time you want the unit to turn off (on standby).

1)Press SELECT – or SELECT + to set the hour, then press SET.

2)Press SELECT – or SELECT + to set the minute, then press SET.

The unit enters source selecting mode.

– SELECT +

4 5

SET

8

– 25 –