JVC CA-MXJ300, CA-MXJ200 manual Troubleshooting

Page 33

Troubleshooting

If you are having a problem with your unit, check this list for a possible solution before calling for service.

If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.

English

Symptom

No sound is heard.

Hard to listen to broadcasts because of noise.

The disc sound is discontinuous.

The disc tray does not open or close.

The disc does not play.

The cassette holders cannot be opened.

Impossible to record.

Operations are disabled.

Unable to operate the unit from the remote control unit.

Cause

Connections are incorrect or loose.

Antennas are disconnected.

The AM (MW/LW) loop antenna is too close to the unit.

The FM antenna is not properly extended and positioned.

The disc is scratched or dirty.

The AC power cord is not plugged in.

Trays are locked.

The disc is placed upside down.

Power supply from the AC power cord has been cut off while the tape was running.

Small tabs on the back of the cassette are removed.

The built-in microprocessor may malfunction due to external electrical interference.

The path between the remote control unit and the remote sensor on the unit is blocked.

The batteries are exhausted.

Action

Check all connections and make corrections. (See pages 8 to 10.)

Reconnect the antennas correctly and securely.

Change the position and direction of the AM (MW/LW) loop antenna.

Extend the FM antenna at the best position.

Clean or replace the disc. (See page 27.)

Plug the AC power cord.

Unlock the trays. (See page 18.)

Place the disc with the label side up.

Turn on the unit.

Cover the holes with adhesive tape.

Unplug the AC power cord and then plug it back in.

Remove the obstruction.

Replace the batteries.

Specifications

Design and specifications are subject to change without notice.

 

Amplifier

Output Power

CA-MXJ300: 70 W per channel, min. RMS, both channels driven into 6 Ω at 1 kHz with no more than 10% total harmonic distortion

CA-MXJ200: 40 W per channel, min. RMS, both channels driven into 6 Ω at 1 kHz with no more than 10% total harmonic distortion

Audio input sensitivity/Impedance (at 1 kHz)

AUX: 300 mV/50 kΩ

Speakers/Impedance: 6 Ω – 16Ω

Tuner

FM tuning range:

87.50 MHz – 108.00 MHz

AM tuning range: MW:

522 kHz – 1,629 kHz

LW:

144 kHz – 288 kHz

Cassette deck

Frequency response

Normal (type I): 50 Hz — 14,000 Hz

CrO2 (type II): 50 Hz — 14,000 Hz

Metal (type IV): 50 Hz — 14,000 Hz (only for playback) Wow and flutter

0.15% (WRMS)

General

Power requirement:

AC 230 V , 50 Hz

Power consumption:

 

CA-MXJ300:

95 W (at operation)

 

8 W (on standby)

CA-MXJ200:

85 W (at operation)

 

9 W (on standby)

Dimensions (approx.):

265 mm x 315 mm x 361 mm (W/H/D)

 

(10 7/16 in. x 12 7/16 in. x 14 1/4 in.)

CD player

 

Mass (approx.):

 

CD Capacity:

3 CDs

CA-MXJ300:

8.7 kg (19.2 lbs)

Dynamic range:

85 dB

CA-MXJ200:

7.2 kg (15.9 lbs)

Signal-to-noise ratio:

90 dB

Supplied accessories

Wow and flutter:

Immeasurable

 

 

See page 8.

– 28 –

Image 33
Contents CA-MXJ300 CA-MXJ200 If in Doubt Consult a Competent Electrician English Deutsch Français CA-MXJ300 CA-MXJ200 Class Laser Product Precautions IntroductionAbout This Manual Contents CA-MXJ300 Location of the Buttons and ControlsPowered Rolling Panel CA-MXJ300 Front PanelDisplay Window CA-MXJ200 These buttons do not function as 1 / Á CA-MXJ200 Front PanelRemote Control Remote ControlGetting Started Connecting AntennasUnpacking FM antennaRelease the finger from the clamp Connecting SpeakersAM MW/LW antenna To connect an outdoor AM MW/LW antennaPress and hold Demo for more than Seconds.DEMO Connecting Other EquipmentTo connect audio equipment To start the display demonstration manuallyCommon Operations Setting the ClockAdjusting the Volume Turning On the Power and Selecting the SourcesSelecting the Sound Modes Reinforcing the Bass SoundTo select the sound modes, press Sound Surround modesTuning in a Preset Station Tuning in a StationPresetting Stations Listening to FM and AM MW/LW BroadcastsLoading CDs Playing Back CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgramming the Playing Order of the Tracks Program Play To check the program contents Select the Random play mode On the unitPlaying at Random Random Play Prepare CDsRepeating Tracks or CDs Repeat Play Prohibiting Disc Ejection Tray LockIf you try to eject CDs Playing Back a Tape Playing Back TapesRecording Tapes on Deck B RecordingPress Eject 0for the deck B Start recording On the unitDubbing Tapes To record on both sides Reverse ModeCD Direct Recording Press DubbingUsing Daily Timer Using the TimersWhen selecting Tuner FM or Tuner AM When selecting CDPress 4or ¢to set the volume level Press TimerTo set the volume level Using Recording TimerTimer setting REC appears on the displayPress Timer until REC appears To turn on On the remote controlPut a recordable cassette into deck B Press Shift On the displayUsing Sleep Timer Timer PriorityMaintenance Handling discsCassette decks Troubleshooting EN, GE, FR, NL, SP, IT 0400KSMMDWHIT SP-MXJ300, SP-MXJ200 Connection Anschluss Aansluitingen Collegamento Tilslutning POD£¡CZENIE Zapojení