JVC CA-MXJ300 manual Using Recording Timer, REC appears on the display, Press Select or Select +

Continued

English

6 Press SELECT – or SELECT + to select the source to play, then press SET.

•Each time you press SELECT – or SELECT +, the source changes as follows:

TUNER FM TUNER AM

AUX TAPE – CD – – –

– SELECT +

4 5

SET

8

10 Press (standby/on) to turn off the unit (on standby) if you have set the Daily Timer with the unit turned on.

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically.

DAILY

TUNER FM: tunes into a specified preset FM station.

=go to step 7.

TUNER AM: tunes into a specified preset AM (MW/LW) station. =go to step 7.

–CD – – –: plays a disc from a specified track of a specified disc. =go to step 7.

•Make sure there is a CD on the selected disc number tray.

TAPE: plays a tape in deck A or B. =go to step 8.

•Make sure that a tape is in the deck whose deck indicator (A or B) is lit on the display.

•Make sure that the tape direction is correct. AUX: plays an external source.=go to step 8.

•To use this setting, the external component has to be equipped with the timer function.

How Recording Timer actually works

The unit automatically turns on, tunes into the specified station, sets the volume level to “MIN,” and starts recording

when the on-time comes (the indicator flashes just before the on-time, and continues flashing while the timer is operating). Then, when the off-time comes (“OFF” appears just before the off-time), the unit automatically turns off (stands by).

The timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•If you have made a mistake while setting the timer, press CANCEL. (However, this does not always work. If CANCEL does not work, press CLOCK/TIMER repeatedly and start from step 1 again.)

On the unit:

1 Put a recordable cassette into deck B.

7 When selecting “– CD – – –”

1)Press SELECT – or SELECT + to select the disc number, then press SET.

2)Press SELECT – or SELECT + to set the track number, then press SET.

The unit enters volume setting mode.

When selecting “TUNER FM” or “TUNER AM”

– SELECT +

4 5

SET

8

2 Press CLOCK/TIMER until	CLOCK/TIMER
“REC” appears on the display.

REC

The REC indicator also starts flashing on the display.

• Each time you press the button, the timer setting mode

changes as follows:

Press SELECT – or SELECT + to select the preset station number, then press SET.

The unit enters volume setting mode.

8 Press SELECT – or SELECT +		– SELECT +
to set the volume level.	4	5

•You can select the volume level from among four levels. If you select “ VOL –

– –,” the volume is set to the last level when the unit has been turned off.

DAILY

9 Press SET to complete the Daily	SET
Timer setting.	8
The DAILY indicator stops flashing and
remains lit. The settings you have done are
shown on the display in sequence.

DAILY ON TIME REC

Canceled	Clock	ON TIME
	setting

(See page 11.)
3 Press CLOCK/TIMER again.	CLOCK/TIMER
“ON TIME” appears for 2 seconds, then the

unit enters on-time setting mode.

REC

REC

– 24 –