JVC CA-MXJ200, CA-MXJ300 manual Connection

Amplifier connection Verstärkeranschluß Raccordement à l'amplificateur Aansulaiten op de versterker Anslutning till en förstärkare Conexión al amplificador Collegamento dell'amplificatore Forstærkertilslutning Vahvistimen liitäntä Po³±czenia ze wzmacniaczem Erõsítõ csatlakoztatás Zapojení zesilovaèe

CONNECTION

•	Turn off power to the whole system before connecting the
	speakers to the amplifier.
•	The nominal impedance of the SP-MXJ300, SP-MXJ200 is 6
	Ω. Select for use an amplifier to which a speaker system with
	the load impedance of 6 Ω can be connected.
•	The maximum power handling capacity of the SP-MXJ300 is
	100W and the SP-MXJ200 is 60W. Excessive input will result
	in abnormal noise and possible damage. In cases where the
	signals described below are applied to the speakers, even if
	the signals are below the maximum allowable input, they may
	cause an overload and burn the wiring of the speakers. Be
	sure to lower the amplifier volume beforehand.
	1) Noise during FM tuning.
	2) High level signals containing high frequency components

Right speaker Rechter Lautsprecher Enceinte droite Rechter luidspreker Altavoz derecho Altoparlante destro Höger högtalare Højre højttaler Oikeanpuoleinen kaiutin

Prawa kolumna Jobb hangszóró Pravý reproduktor

Amplifier output terminals Ausgang des Verstärkers Bornes de sortie de l'amplificaterur Uitgangsaansluitengen van de versterker Terminales de salida de amplificador Terminali de uscita dell'amplifcator Utgångar på förstärkaren Forstærkerudgangsbøsninger Vahvistimen ulostuloliittimet Przy³±cza wyj¶cia ze wzmacniacza Erõsítõ kimeneti csatlakozók Výstupní zdíøky zesilovaèe

SPEAKERS
RIGHT	LEFT

Left speaker

Linker Lautsprecher Enceinte gauche Linker luidspreker Altavoz izquierdo altoparlante sinistro Vänster högtalare Venstr højttaler Vasemmanpuoleinen kaiutin

Lewa kolumna

Bal hangszóró

Levý reproduktor

	produced by a tape deck in the fast forward mode.
3)	Click noise produced when turning power of other compo-
	nents on and off.
4)	Click noise produced when connecting or disconnecting
	cords with the power on.
5)	Click noise produced when the cartridge is replaced with
	the power on.
6)	Click noise produced when operating amplifier switches.
7)	Continuous high frequency oscillation or high pitch electroni-
	cally produced musical instrument sound.
8)	Howling when using a microphones.

Black Svart

Schwarz Sort

Noir Musta

Zwart Czarny

Negro Fekete

Nero Èerný

SPECIFICATIONS

Type	: 2-way 2-speaker bass-reflex
	type
Speaker units	: Dual Duct System
Woofer	: 16 cm (6-5/16 in.) cone × 1
Tweeter	: 4 cm (1-5/8 in.) cone × 1
Power Handling Capacity
SP-MXJ300	: 100 W
SP-MXJ200	: 60 W
Impedance	: 6 Ω
Frequence Range	: 45 Hz - 22 000 Hz
Sound Pressure Level	: 88 dB/W·m
Dimensions (W × H × D)	: 215 mm × 315 mm × 273 mm
	(8-1/2 in. × 12-7/16 in. × 10-3/4 in.)
Mass	: 3.5 kg (7.8 lbs) each

Design and specifications subject to change without notice.

2