1260OM 5/31/06 7:11 PM Page 38
Workout Programs (continued)
Beginning the Program
During idle mode, the message window displays a message “SELECT A PROGRAM”. To begin this program, press “Cross Training” key until “Glute Burner” program LED indicator lights up.
Accepting default values or Entering the program setup mode
When the message display flashes, “GLUTE BURNER”, it indicates you are about to select the Glute Burner program. It then scrolls “PRESS ENTER TO ADJUST OR START TO BEGIN” and wait for an instruction.
•Press “Start” key to accept current default values and begin Glute Burner program workout.
–Default Time = 30 minutes
–Default Intensity level = a preset intensity profile with default Intensity difficulty level = L1.
–Default Incline level = a preset incline profile with default Incline difficulty level = L1.
•Or press “Enter” to enter program setup mode. The message display will take you through the program setup mode step by step as below: (same as Manual program setup)
–Entering Age
–Entering Weight
–Entering Time
During the Program
Once Start key is pressed, the Warm Up will be active. See Warm Up mode section for details.
Display
•When Warm Up is completed, the message display will turn into workout data display and display four default data: time, level, calories & pulse.
•Press “Select” button under each group to select your desired data display.
Adjustment
•Press “Level Up/Down” key to adjust the intensity difficulty level from L1 to L10. The dot matrix window will update the intensity profile accordingly.
•Press “Incline Up/Down” key to adjust the incline difficulty level from L1 to L10. The dot matrix window will update the incline profile accordingly.
•Personal Trainer program – Personal Trainer program cannot be active during Glute Burner program. See Personal Trainer program section for details.
•HR Lock program – Press “HR Lock” key to switch to target HR program if there is a valid pulse. See HR Lock program section for details.
Ending the Program
•When program time is up or Stop key is pressed, this program will end and Cool Down will be active.
•The message display will flash a message “PROGRAM END”& “COOL DOWN”. See Cool Down mode for details.
•“Start” key could be pressed to
34 | 1260Ef Owner’s Manual |
|
|