8.Press three 50mm x 75mm Inner Caps (58) into the Butterfly Top Frame (7).
Attach the Butterfly Top Frame (7) to the Butterfly Upright (3) with two M10 x 95mm Bolts (92), two M10 Washers (91), and two M10 Nylon Locknuts (87). Do not tighten the Locknuts yet.
Attach the Butterfly Top Frame (7) to the Top Frame (6) with an M10 x 70mm Bolt (134), an M10 Washer (91), and an M10 Nylon Locknut (87). Do not tighten the Locknut yet. Make sure the Bolt is inserted through the indicated hole in the Top Frame; a bolt will be inserted through the other in a later step.
9.Orient the Right Weight Guides (42) with the ellipse holes on top. Slide the Weight Guides into the bracket on the Short Base (2). Attach the Guides to the Base with an M10 x 155mm Bolt (95), two 19mm Spacers (86), two M10 Washers (91), and an M10 Nylon Locknut (87).
Slide two Weight Bumpers (49) onto the Right Weight Guides (42). Slide eleven Weights (44) onto the Guides. Make sure the slots for the
Weight Pin (not shown) are on the indicated side and on the bottom of the Weight.
Press a Weight Tube Bumper (48) into the Long Weight Tube (43). Insert the Tube into the stack of Weights (44) as shown.
Lubricate the indicated holes in a Top Weight (45) with grease. Slide the Top Weight onto the Right Weight Guides (42). Make sure the groove for the pin on the Long Weight Tube (43) is on the bottom.
Attach the Right Weight Guides (42) to the Butterfly Top Frame (7) with an M10 x 155mm Bolt (95), two M10 Washers (91), and an M10 Nylon Locknut (87). Do not tighten the
Locknuts yet.
8 | 92 |
|
|
| 91 | 91 |
|
|
|
| |
| 58 | 87 |
|
|
|
| |
| 7 |
| 58 |
|
|
| |
|
|
| 134 |
58 |
|
| 91 |
|
|
| |
| 3 |
|
|
|
|
| 87 |
| 87 |
|
|
9 |
|
|
|
| 95 |
| |
| 91 |
|
|
91 |
|
|
|
87 |
| Ellipse |
|
|
| Holes |
|
45 |
| Lubricate |
|
Pin | 43 |
|
|
| 7 |
| |
42 |
|
| |
42 |
|
| |
|
|
| |
48 |
|
|
|
Slot |
|
|
|
|
| 44 |
|
|
| 95 |
|
| 49 |
|
|
49 | 91 |
|
|
|
|
| |
87 | 86 |
|
|
91 |
|
|
|
|
|
| 2 |
9