Gold's Gym GGSY69530 manual Cable Assembly

24.Press a 50mm Square Inner Cap (43) into a Butterfly Arm (20).

Wet a Fly Handle (66) and the inside of a Long Foam Pad (97) with soapy water. Slide the Foam Pad onto the Handle.

Attach a Fly Handle (66) to the Butterfly Arm (20) with two M10 x 25mm Button Screws (60) and two M10 Washers (74).

Repeat this step with the other Butterfly Arm (not shown). Make sure that the Fly Handle is oriented as shown in step 25.

25.Lubricate an M10 x 80mm Bolt (86) with grease. Attach the left Butterfly Arm (20) to the Left Fly Pivot (21) with the Bolt and an M10 Nylon Locknut (75).

Attach the right Butterfly Arm (20) to the Right Fly Pivot (22) in the same manner.

Cable Assembly

26.IMPORTANT: Refer to the CABLE DIAGRAMS on pages 27 and 28 for help identifying the cables.

Locate the Butterfly Cable (64). Attach the Cable to the Left Fly Pivot (21) with an M8 x 58mm Shoulder Bolt (89), two M8 Washers (90), and an M8 Nylon Locknut (54).

27.Wrap the Butterfly Cable (64) over a “V”-pulley

(40).Attach the “V”-pulley and a Large Cable Trap

(39)to the bracket on the Left Upright (6) with an

M10 x 60mm Bolt (82) and an M10 Nylon Locknut

(75).Make sure that the Cable Trap is turned to hold the Cable in the groove of the “V”-pulley.

24
	20
	97	66
74
60
	43
25
75
		20
	86
21	Lubricate
22
20
26	89
	64
	90
	21
	90
	54
27	82
39
	40
	64
6
75

14