Gold's Gym GGSY69530 manual Bracket Large Ball

36.Wrap the Low Cable (63) over a 90mm Pulley (38). Attach the Pulley and a Cable Trap (37) between the second set of holes from the bottom of the two Pulley Plates (36) with an M10 x 48mm Bolt (23) and an M10 Nylon Locknut (75). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley.

37.Wrap the Low Cable (63) under a 90mm Pulley (78). Attach the Pulley and a Cable Trap (37) to the Left Base (2) with an M10 x 48mm Bolt (23) and an M10 Nylon Locknut (75). Make sure that the Cable Trap is turned to hold the Cable in place.

38.Wrap the Low Cable (63) over a 90mm Pulley (38). Attach the Pulley to the bracket (bracket 1) on the Left Top Frame (11) with an M10 x 45mm Bolt (78) and an M10 Nylon Locknut (75).

Wrap the Low Cable (63) over another 90mm Pulley (38). Attach the Pulley to the other bracket on the Left Top Frame (11) with an M10 x 45mm Bolt (78) and an M10 Nylon Locknut (75).

39.Thread an M12 Nut (80) onto the Low Cable (63) as far as it will go. Slide a 50mm Washer (59) onto the Cable and thread the Cable into the left Weight Tube (34) until the Cable is tight. Tighten the Nut against the Washer. Do not overtighten the Cable into the Weight Tube or the Top Weight (31) will be lifted off the weight stack.

40.Locate the High Cable (61). Route the small ball on the Cable (61) through the Right Upright (5) and under a 90mm Pulley (38). Make sure the

Cable is over the welded bar inside the Upright. Attach the Pulley inside the Upright with an M10 x 78mm Bolt (85), two M10 Washers (74), two 17mm Spacer (58), and an M10 Nylon Locknut (75).

36
			75	36
				23
			37	38
				63
37
				75
			63	2
23	37		38
38				11
				75
			78
		Bracket 1		75
			38	38
			63
39
				63
				80
			31	59
				34
40
75		58		38
74				58
Large
				74
Ball				85
61		5

17