Precor EFX manual 536i Elliptical Fitness CrossTrainer Assembly Guide

CAUTION: Avoid cross-threading. Make sure the moving arm assembly is well-aligned with the pivot tube before wrench tightening. Any damage caused during installation is not covered by the Precor Limited Warranty.

Attach one moving arm assembly at a time. Align and thread it carefully into the pivot tube. To secure it, use a ½-inch open end wrench and tighten the moving arm pivot joint. Guide the moving arm to its equilibrium point and let it rest there. Perform the same step for the opposite side.

Attach the lower link arms onto the moving handlebars using two joint connector screws (H), two star washers (K), and two joint connector nuts (J). Perform this step on one handlebar at a time. Wrench tighten using a 5mm hex key.

Important: Be aware of the handlebar locations during assembly. When assembling the lower link arms, position yourself at the front of the EFX.

536i Elliptical Fitness CrossTrainer Assembly Guide 7