If the Computer is powered by batteries

If you have any problems with your Computer: First check this manual to be sure you have followed the assembly instructions correctly.

Computer Installation:Follow Step 9 on page 10 of the Owner's Manudi

Computer Tube Assembly: Follow Step 6 on page 9 of thisManual

(Make sure all wire connectors ore firmly attached and 'click" into place).

If the Computer is powered by batteries and:

The Computer does not illuminate at all

•Reconnect the (10) wire connector at the base of the Computer and

the (5] wire connector inside the Computer Tube.

•Reinstall the batteries using ir_struotions on page 10,step 9.

•Install new batteries, Although the batteries are new when they are shipped from the factory, over time they will slowly discharge.

The Computer displays "E t"

•Make sure the (5) wire connector inside the Computer Tube is securely fastened.

•Reconnect the (10) wire connector at the base of the Computer

and the (5) wire connector Inside the Computer Tube.

The Computer displays "E 1"

•Make sure the (5) wire connector inside the Computer Tube is securely fastened.

NOTE: ff the AC Adapter receptacle L_plugged into the Computer, but the adapter is not plugged into an AC wall outlet (or has been removed)

from the AC wall outlet, the Computer will _.To reset the

Computer, the AC Adapter must be plugged into the AC wall odilet.

The Computer is illuminated but does not display Speed or Distance

•Reconnect the (10) wire connector at the base of the Computer and

the the (2) wire connector Inside the Computer Tube.

The Computer is illuminated but does not display a pulse reading

•You nlust press the START button on the Computer, and have both

hands placed firmly on the Pulse Sensors on the Rear Handlebar for

NOTE: Depending on what program you have set the Computer to, after

pressing the START butlon,it will take the Computer approximately 6 -1 I seconds before it will display your pulse reading. If you take one hand off

of the PuLse Sensor, the Computer will stop displaying your pulse.

NOTE: Keeping your Pulse Sensors cleon will provide better conductivity

between your hands, and the Pulse Sensor.

To insure a more accurate pulse reading, both hands must grab the Pulse

Sensors on the Rear Handlebar conlJnuously for appmxlmately 6 seconds.

(t0) wire connector leads to

the motor/magnetic sensor/

AC adapter jack

_'_18