Precor Complete Guide to Installing the Lat Pulley Cable on the S3.19 Fitness Equipment

S3.19 Assembly and Maintenance Guide

7. Install Lat Pulley Cable

Note: All pulleys (except the floating pulleys) are installed in the frame assemblies. As you begin each new step, remove the fasteners and pulley. Feed the cable around the pulley as shown, and then replace the fasteners and finger tighten. Wrench tighten all pulley fasteners once you have completed the installation of each cable assembly.

A.Start at the Top Beam and feed the threaded end of the Lat Pulley Cable 130208 over one 4½-inch pulley. Attach the pulley to the Top Beam using one 4-inch hex head bolt

two 1¼-inch shoulder spacers one locknut

B.Feed the cable over the second 4½-inch pulley. Attach the pulley to the Top Beam using

one 4-inch hex head bolt

two 1¼-inch shoulder spacers one locknut

C.Feed the cable over the upper 3½-inch pulley located in the Press Arm assembly. Attach the pulley to the Press Arm assembly using one 2-inch zinc hex head bolt

two zinc flat washers one zinc locknut

D.Feed the cable over the upper 3½-inch pulley located in the Main Upright. Attach the pulley to the Main Upright using

one 4-inch hex head bolt

two 1¹⁄₄-inch shoulder spacers one locknut

Pulley assemblies

4½-inch Pulley

1 - bolt

2 - shoulder spacers

1 - locknut

3½-inch Pulley (used on gray painted parts)

1 - bolt

2 - shoulder spacers

1 - locknut

3½-inch Pulley (used on titanium parts)

1 - zinc bolt

2 - zinc washers

1 - zinc locknut

3½-inch Pulley (used on gray painted parts)

1 - bolt

2 - washers

1 - locknut

Lat Pulley Cable 130208 A

C

B

D

1

2

3

4

5

6

Step 7. Install Lat Pulley Cable

page 19