Precor Comprehensive Manual for Leg Extension Cable Installation and Assembly for S3.19 and S3.21

S3.19 Assembly and Maintenance Guide

8. Install Leg Extension Cable

A.Remove the hex head bolt from the Gusset which is welded to the Base Frame. Place the end of the Leg Extension Cable 130210 on the bolt as shown. Secure the cable end by reinserting the fasteners: one 2¼-inch hex head bolt

one locknut Wrench tighten.

B.Disassemble the 3½-inch pulley at the base of the Multiplier Arm. Wrap the cable around the pulley and secure it using

one 2¼-inch zinc hex head bolt 1 cable guard

two zinc flat washers one zinc locknut Wrench tighten.

C.Feed the cable through the Main Base and beneath the 3½-inch pulley located inside the Gusset.

D.Attach the threaded end of the cable to a Single Floating Pulley. Continue turning the screw three to four full turns to secure it inside the floating pulley housing. Rest the Single Floating Pulley on the floor.

	Multiplier Arm
			C
			Leg Extension
			Cable 130210
			Gusset
1 - 2¼"zinc bolt	B
1 - cable guard
2 - zinc washers
1 - zinc locknut
Single Floating
Pulley	1 - 2" bolt	D		1 - 2¼" bolt
	2 - washers		A 1 - locknut
	1 - locknut
1	2	3	4	5	6

Step 8. Install Leg Extension Cable

page 21