S3.19 Assembly and Maintenance Guide
11. Install Shrouds
Note: Read and follow the steps found in Cable Adjustments and Maintenance to lubricate the guide rods and make the appropriate cable adjustments prior to installing the Shrouds. The floating pulleys, guide rods, and selector stem are inaccessible once the acrylic Shrouds are attached.
Two metal Upper Shrouds and two acrylic Shrouds
are attached to the Main Frame. Complete the assembly steps for one side of the unit before moving to the other.
Important: Handle the shrouds with care.The acrylic shrouds require special handling as they are easily scratched. For proper care and maintenance, refer to Adjustments and Maintenance.
A.Attach an acrylic Shroud to each side of the Main Frame using
fourteen -
Start with the two bottom fasteners and work toward the top. Ask your assistant to hold the Shroud in place while you insert the spacers and fasteners. Alternately finger tighten all six fasteners while adjusting the alignment.
Note: The frosted side of the acrylic Shroud faces the Weight Stack. Install the Shrouds so the cutouts allow access to the Weight Stack Pin.
B.Attach the Upper Shrouds to the Top Beam using six
six black plastic washers six tapered spacers
C.Adjust the Upper Shroud so its bottom edge is parallel to the top edge of the acrylic shroud. Wrench tighten using a 5mm hex key.
CAUTION: Do not over tighten. You can crack or warp the Shroud if too much pressure is applied to
6 - 1¾" zinc buttonhead bolts
B6 - black plastic washers
6 - tapered spacers
Shroud
(frosted side faces weight stack)
Cutout in
Shroud
The Hi/Lo Pulley Assembly is not shown in this illustration.
14 - 1¾" buttonhead screws | A |
14- tapered spacers |
Shroud
(frosted side faces weight stack)
the fasteners.
12
3
456
Step 11. Install Shrouds
page 27