S3.19 Assembly and Maintenance Guide
2. Cable Adjustments
You may need to adjust the cables after installation and periodically thereafter. If the cables remain slack after you have followed the steps found in Cable Tension, perform the following:
A.Remove the Weight Pin and set it aside.
B.Loosen the Jam Nut on the Weight Stack threaded end to expose additional threads. Adjust the threaded end until the slack is removed.
C.Loosen the Jam Nuts on the Floating Pulleys threaded ends. Adjust the threaded ends until the slack is removed. Make sure the amount of threads exposed on one pulley is about the same as the other pulleys.
D.Check the Top Cap Weight to make sure it remains
E.Check the Selector Stem alignment by inserting the Weight Pin into every hole on the Weight Stack.
F.Replace the Weight Pin into the Weight Stack.
Threads
Jam Nut
A
1 2
4 
5 
6 
7 8 9 10 11 12 13 14 15
BC
Top Cap
Weight
Top Weight
Plate
Jam Nut
Top Cap Weight is fully
Dseated on the top weight. No gap should appear.
E
Bottom Weight Plate
Thread exposure should remain the same for all three Floating Pulleys.Two Floating Pulleys are on the main unit and another is attached to the Hi/Lo Pulley.
1
2
3
4
5
6
Cable Adjustments and Maintenance, continued
page 33