Maintenance, Guide Rods | Precor S3-19 manual

S3.19 Assembly and Maintenance Guide

4. Maintenance

Guide Rods

AApply one tube of lubricant to each Guide Rod.

B. Lubricate the Guide Rods every six months.

CAUTION: The lubricant can stain clothes. Wear proper attire when lubricating the Guide Rods.

Lubricant	Guide Rod
A
	1
	2
	3
	4
	5
	6
	7
	8
	9
	10
	11
	12
	13
	14
	15

Inspection

Inspect the unit daily.

Look and listen for frayed or worn parts, loose fasteners, cable tension issues, unusual noises, and any other indications that the equipment may be in need of service.

You are responsible for the proper maintenance of the unit as discussed in this manual. For other service issues, contact Customer Support. Refer to Obtaining Service.

Shrouds

CAUTION: Clean the Shrouds with product specifically labeled as safe for acrylic. Use a clean, nonabrasive cloth and light pressure to avoid scratching the acrylic surface.

The acrylic Shrouds on the S3.19 are easily scratched or damaged through improper cleaning techniques. To avoid problems, dust the shrouds often with a clean, lint-free cloth and light pressure. Avoid rubbing dirt or grit into the surface. If you use glass cleaner or a similar product, make sure the label states that it is safe to use on Plexiglas® or acrylic products.

Important: DO NOT use ketones, aromatics,esters, halogens, window cleaning sprays, alcohol, kitchen scouring compounds,or solvents (such as acetone, benzene, gasoline, carbon tetrachloride, or thinners). Do not use ammonia-based cleaning solutions because the ammonia destroys the plastic coating.

To remove light scratches on the smooth side only, use a buffing compound such as, car wax. Lightly buff the acrylic sheet using a clean buffer until the scratches disappear.

Cable Adjustments and Maintenance, continued

page 35