Precor S3-19 manual Install Leg Press Option Cable Connection

Page 22

S3.19 Assembly and Maintenance Guide

9.Install Leg Press Option Cable Connection

A.Disassemble the 3½-inch pulley attached to the base frame bracket and feed the threaded end of the Leg Press Option Cable 130211 under the pulley. Reattach the pulley to its bracket using one 2-inch hex head bolt

two flat washers one locknut Wrench tighten.

B.Attach the threaded end of the cable to the Single Floating Pulley. Continue turning the screw three to four full turns to secure it inside the floating pulley housing. Rest the Single Floating Pulley on the floor.

1	- 2" bolt	A		B
2	- washers	A
1 - locknut
			Leg Press Option
			Cable 130211
1	2	3	4	5	6

Step 9. Install Leg Press Option Cable Connection

page 22

Image 22

Contents S3.19 Page Important Safety Instructions Personal Safety During AssemblyTable of Contents Before You Begin Unpacking the EquipmentPreparations Required ToolsAssemblyInstructions Assembly InstructionsOpen the Box Assemble Main Structure Top Beam Assemble Leg Extension Install Rollers and Seat Pads Incline Back Bracket Pad Seat Pad Assemble Weight Stack Guide Rod Upper Frame ¾ buttonhead Crosspiece Top Cap Bolts Assemble Press Arm Press Arm Assembly Install Hi/Lo Pulley Assembly Install Lat Pulley Cable Feed the cable over the lower 3½-inch pulley Install Leg Extension Cable Install Leg Press Option Cable Connection Install Mid Pulley Cable and Hi/Lo Pulley Connection Mid Pulley Bracket Single Floating Pivoting Pulley Bracket Bolt Washers J Locknut Install Shrouds Two metal Upper Shrouds and two acrylic ShroudsAttach Accessories Move the Hi/Lo Pulley Apply Weight Decals and Lubricant Cable Adjustments and Maintenance Cable Tension Cable Adjustments Bottom Weight PlateSelector Stem Adjustments Important Do not remove the socket head boltMaintenance Guide RodsPrecor Residential Equipment Limited Warranty Limited WarrantyThank You and Welcome to Precor Tell US about Your NEW Precor Product Page S3.19 Specifications