JVC RX-D411S manual Operating procedure, Setting the speakers, Subwoofer, Back OUT

Page 34

Operating procedure

 

1, 7

3, 5

2, 4

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

On the front panel ONLY:

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

Ex.: When setting the DIGITAL IN 1 terminal

1Press SETTING.

MULTI JOG now works for the setting operation.

2Turn MULTI JOG until the item you want to set appears on the display.

•As you turn MULTI JOG, the setting items change as follows:

Setting the speakers

To obtain the best possible surround effect from the Surround and DSP modes, register the setting about the speaker after all connections are completed.

•If you have performed Precise Surround Setup on pages 16 to 18, the following settings are not required.

•You cannot adjust these items directly from the remote control.

7 Setting subwoofer information—

SUBWOOFER

Select if you have connected a subwoofer or not.

SUBWFR YES Select when you have connected a subwoofer.

The subwoofer indicator () lights up on the display. You can adjust the subwoofer output level (see page 36).

SUBWFR NO Select when you have not connected a subwoofer. Selecting this changes the front speaker size to “LRG” (see below).

Initial setting: NO

SUBWOOFER Ô FRONT SPK Ô CENTER SPK Ô SURROUND SPK Ô S BACK SPK Ô S BACK OUT Ô DIST UNIT Ô FRONT L DIST Ô FRONT R DIST Ô CENTER DIST Ô SURR L DIST Ô SURR R DIST Ô

S BACK DIST Ô S BACK L DIST Ô S BACK R DIST Ô EX/ES/PLIIx Ô DUAL MONO Ô SUBWOOFER OUT Ô CROSSOVER Ô LFE ATT Ô MIDNIGHT MODE Ô DIGITAL IN 1 Ô DIGITAL IN 2 Ô DIGITAL IN 3 Ô AUDIO DELAY Ô HDMI SELECT Ô CMPNT SELECT

ÔVIDEO OUTPUT Ô AUTO MODE Ô (Back to the beginning)

3Press SET.

The current setting of the selected item appears.

4Turn MULTI JOG to select the appropriate setting.

7 Setting the speaker size—FRONT SPK (front speakers), CENTER SPK (center speaker), SURROUND SPK (surround speakers), S BACK SPK (surround back speakers)

Register the sizes of all the connected speakers.

LRG (large)

Select when the cone speaker size is larger

 

than 12 cm.

 

 

SML (small)

Select when the cone speaker size is smaller

 

than 12 cm.

 

 

NO

Select when you have not connected

 

the speaker. (Not selectable for the front

 

speakers.)

 

 

Initial setting:

LRG (for the front speakers)

 

SML (for the other speakers)

NOTES

•If you have selected “SML (small)” for the front speaker size, you cannot select “LRG (large)” for other speakers.

•When “SUBWOOFER” is set to “NO,” the front speaker size is fixed to “LRG (large)” (and you cannot select “SML (small)”).

•When “SURROUND SPK” is set to “SML (small),” you cannot select “LRG (large)” for the surround back speaker.

•When “SURROUND SPK” is set to “NO,” the surround back speaker is fixed to “NO.”

DVR/DVD Ô VIDEO Ô VCR Ô TV

5Press SET.

Your setting is stored.

6Repeat steps 2 to 5 to set other items if necessary.

7Press SETTING.

The source indication resumes on the display.

7 Setting the surround back speaker(s)—

S BACK OUT

Register the number of the surround back speaker(s).

SB OUT 1SPK Select when you use a single surround back speaker.

SB OUT 2SPK Select when you use 2 surround back speakers.

Initial setting: 2SPK

NOTES

•When “S BACK SPK” is set to “NO,” you cannot select “S BACK OUT.”

•When “S BACK OUT” is set to “1SPK,” connect the surround back speaker to the left surround back speaker terminal (see page 8). No sound comes from the surround back speaker if you connect it to the right surround back speaker terminal.

30

Page 33 Page 35
Image 34
Page 33 Page 35
Contents RX-D411S Important for the U.K Information for Users on Disposal of Old Equipment Above ALL Features PrecautionsTable of Contents When operating a DVD player, set the mode selector i to DVD Remote controlParts identification DVR/DVD, VCR, VIDEO, TV, USB, FM, AM Display windowFront Panel TA, NEWS, InfoVideo IN, DVR/DVD Rear PanelVideovcr IN, DVR/DVD IN, Monitor OUT CENTER, SUBWOOFER, SURR-L, SURR-RPutting the batteries in the remote control Before installationGetting started AM MW antenna connection Connecting the FM and AM MW antennasFM antenna connection Close the terminal Connecting the speakersConnecting the speakers Turn the knob clockwiseHdmi connection Connecting video componentsConverting video signals into Hdmi signals Turn off all components before making connectionsFor an analog decoder Scart Terminal SpecificationsScart connection For T-V LinkTo component video output Audio/video connectionComponent S-video Composite To left/right audio channel outputWith analog method When you enjoy the sound recorded in DVD-AudioWith digital method DBS tuner, etc White Red Connecting a VCR and another video componentConnecting a TV Composite video cable not supplied Video cable not suppliedDigital output terminal Connecting the power cordDigital audio connection Digital input terminalsUSB connection How to install the USB driversCheck if the drivers are correctly installed Turn on your PCOperating procedure Before starting Precise Surround SetupVolume of test tones is not adjustable Put on the microphones PSS indicatorIf Precise Surround Setup is not completed properly = SW SubwooferUnplug the earphone-type microphones From the remote control onlyTurning the frequency optimizing function off Press Test again to stop the test toneTroubleshooting for Precise Surround Setup Possible cause SolutionBasic operations 1Turn on the power3Adjust the volume 2Select the source to playSelecting the video input setting Selecting the video and audio input settingsListening with headphones Selecting the audio input settingChanging the display brightness From the remote control only Press Dimmer repeatedlyTo restore the sound, press Muting again Linear PCMFrom the remote control only Press Sleep repeatedly Turning off the power with the Sleep TimerBasic adjustment of auto memory Making sounds naturalTo store the preset stations Tuning in to stations manuallyUsing preset tuning Tuner operationsSelecting the FM reception mode To tune in a preset stationOn the display Press Display while listening to an FM stationPress PTY Search while listening to an FM station About characters shown on the displayPTY codes Description of the PTY codesTest Switching to broadcast program of your choice temporarily News NewsBasic settings Basic setting itemsSubwoofer Operating procedureSetting the speakers Back OUTAuto Activating the EX/ES/PLIIx setting- EX/ES/PLIIxSetting the speaker distance OFFMain Setting bass soundSetting the crossover frequency-CROSSOVER SW LFESetting the Audio delay level Using the Midnight modeLFE ATT Hdmi VCR Setting the auto function modeHdmi Video ManualPress Adjust Sound adjustmentsBasic adjustment items Turn Multi JOG to adjust the selected itemFrom the remote control Adjusting the speaker output levelsAdjust the speaker output levels You can adjust the speaker output levelsATT on Adjusting the sound parameters for the Surround/DSP modesEffect ATT NormalCenter Width DimensionCenter Align Dolby Digital Introducing the Surround modesDolby Surround DTS Extended Surround DTS-ES DTSDTS Digital Surround DTS 96/24Digital Acoustic Processor DAP modes About other digital signalsIntroducing the DSP modes Mono Film3D Headphone mode Using the Surround/DSP modesDTS Virtual Surround Back About the DSP modesAuto Surround DTS-ESTo cancel Surround/DSP modes From the remote control Select and play any sourceTurn Multi JOG to select the Surround DSP mode you want Press SurroundVCR Operating other JVC productsChannel + Release DVR/DVD DVD recorder or DVD playerSET Manufacturer codes for TV Codes JVCManufacturer codes for VCR Codes VCRIf more than one code is listed for your brand of VCR, try CGMTry to operate your DVD player by Pressing DVR/DVD MenuProblem Possible Cause Solution TroubleshootingPower Set the mode selector to the proper Remote control TunerButton before operation Specifications HdmiRX-D411S AUDIO/VIDEO Control Receiver

RX-D411S specifications

The JVC RX-D411S is a versatile and robust audio receiver designed to meet the needs of modern music enthusiasts and home theater aficionados alike. This model stands out with its combination of superior sound quality, user-friendly features, and an array of connectivity options.

At the heart of the RX-D411S lies its advanced amplification system that delivers a power output of 100 watts per channel, ensuring that your audio experience is both dynamic and satisfying. This power rating enables the receiver to drive a wide variety of speakers, making it suitable for various home setups, whether for music listening or movie watching.

One of the most notable features of the RX-D411S is its support for multiple audio formats, including Dolby Digital and DTS surround sound. This allows users to enjoy their favorite movies and TV shows with immersive soundscapes that enhance the viewing experience. Additionally, the receiver is equipped with an FM/AM tuner, providing access to an extensive range of radio stations.

The RX-D411S also incorporates advanced digital signal processing (DSP) technology, which optimizes audio output for various environments, ensuring rich and clear sound reproduction regardless of the space. For music lovers, the receiver supports several audio sources, including CD players, vinyl turntables, and streaming devices, connecting seamlessly through multiple inputs like optical, coaxial, and RCA.

In terms of connectivity, the RX-D411S comes equipped with Bluetooth technology, allowing users to stream music wirelessly from their smartphones and other Bluetooth-enabled devices. This feature adds a layer of convenience to the user experience, enabling effortless access to music libraries and streaming services.

The receiver is designed with a sleek and modern aesthetic, making it a stylish addition to any home entertainment center. Its intuitive interface, supported by a clear and concise remote control, enhances user experience, allowing for easy navigation and adjustments.

Overall, the JVC RX-D411S is an impressive audio receiver that combines power, versatility, and cutting-edge technology. With its broad feature set and reliable performance, it remains a popular choice among audio enthusiasts seeking to enhance both their music and home theater experiences.
Top Page Image Contents