Weider 831.153931 user manual Locate the Leg Lever Cable 75, which is, Ed pin on the other end

34. Remove the preattached 3 1/2” Pulleys (78) from			34
the Double “U”-bracket (62).
Wrap the Butterfly Cable (69) under a 3 1/2” Pulley					69
					78
(78). Attach the Pulley to the Double “U”-bracket
(62) with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon
Locknut (87).
				93	87
				62
35. Wrap the Butterfly Cable (69) over a “V”-pulley (55).			35	18
Attach the Pulley and a Long Cable Trap (102) to
the other bracket on the Butterfly Upright (3) with a				102
3/8” x 2 1/2” Bolt (18) and a 3/8” Nylon Locknut
			69
(87). Make sure that the Long Cable Trap is						3
turned to hold the Cable in the groove of the				55
Pulley.
						87
36. Attach the Butterfly Cable (69) to the Pivot Bracket			36	103	69
(70) on the Right Butterfly Arm (26) with a 5/16” x 1”
Shoulder Bolt (103) and a 5/16” Nylon Locknut (86).				70
				26	86
37. Locate the Leg Lever Cable (75), which is 98		1/2”	37
long and has an eyelet on one end and a thread-
ed pin on the other end.	Route the eyelet end of			86
the Cable through the Seat Upright (9) and attach it						75
to the tab on the Leg Lever (10) with a 5/16” x 1”
Shoulder Bolt (103) and a 5/16” Nylon Locknut (86).						9
				10
				103
38. Attach a 3 1/2” Pulley (78) inside of the Seat			38
Upright (9) with a 3/8” x 2 3/4” Bolt (101), two 3/8”
Washers (91), two 1/2” Spacers (89), and a 3/8”			91	89
Nylon Locknut (87), as shown.					78	75
			87
						91
					89	101
		15