Weider 831.153931 user manual R1202A, X 3 3/4 Bolt

Page 30

PART IDENTIFICATION CHART—Model No. 831.153931

1/2" Nut (118)

1/2" Washer (1)

3/8" Nylon Locknut (87)

3/8" Washer (91)

3/8" Nylon Jamnut (113)

5/16" Washer (90)	5/16" Nylon Locknut (86)

1/4" Nylon Locknut (34)

1/4" Washer (97)

1/2" Spacer (89)

3/4" Spacer (124)

R1202A

Cable Clip (83)

4 1/2" Pulley (119) (Not shown to scale)

"V" Pulley (55) (Not shown to scale)

3 1/2" Pulley (78) (Not shown to scale)

5/16" x 3 1/2" Bolt (94)

3/8" x 3 3/4" Bolt (122)

5/16" x 3 3/4" Bolt (92)

3/8" x 6 1/2" Bolt (95)

Image 30

Contents Model No Serial No Serial Number Decal under seatPatent Pending Table of Contents Sure that the cables are on all of the pulleys Important PrecautionsWeight system in the location shown DecalUsing the weight system Before YOU BeginAssembly Them in place Each Carriage Bolt. Do not tighten the Nylon Locknuts yet Nylon LocknutsDo not tighten the Nylon Locknuts yet Locknut 86 onto each Carriage Bolt Hole in the Swivel Upright AdjustmentTwo indicated 5/16 x 2 1/2 Carriage Bolts 110 En the Nylon Locknuts yetMake sure Grooved side is facing downwardDo not tighten the Locknuts yet 8 Nylon Jamnut 113 as shown With the Bolt and a 3/8 Nylon JamnutMust be able to pivot easily. R EasilyLong and has an eyelet on each end Groove of the Pulley Cable in the groove of the PulleyBolt 100 and a 3/8 Nylon Locknut Attach the end of the Swivel Cable 17 toLocate the Butterfly Cable 69, which is A 3/8 Nylon JamnutPulley Locknut 87. Make sure that the Long CableLocate the Leg Lever Cable 75, which is Ed pin on the other endEnd and a ball on the other end Upright 3 with a 3/8 x 3 3/4 Bolt 122, a 3/8Washer 91, and a 3/8 Nylon Jamnut A 3/8 Nylon Locknut 119 122 121 113 Cage 120With a 3/8 x 2 Bolt 100 and a 3/8 Nylon A 3/8 Nylon Locknut 120A 3/8 Nylon Jamnut OnlyNylon Locknut 120 124Nut against the 1/2 Washer 1. Rem A 3/8 Nylon LocknutNut 118 halfway onto the end Stack. Replace the PinRepeat this step with the other end of the Squat Arm Nylon Locknuts yetTighten all of the 3/8 Nylon Locknuts 87 used in this step Backrest than the top. Attach the Squat Backrest to Adjustments PressIng any exercise Adjusting the Squat ARM or Swivel Carriage 115Weight Resistance Chart Lbs TopTroubleshooting Pulley and the Cable Trap between the higher setCable Diagrams ButterflySwivel High Cable Leg Lever CableSwivel Low Full 90 DAY Warranty Bags, check to see if it has been pre-assembled R1202A X 3 3/4 BoltPage Round Inner Cap 2 x 2 Inner Cap 2 1/2 Inner Cap Save this Part LIST/EXPLODED Drawing for Future Reference Part LIST-Model No Key Qty DescriptionExploded