Weider 831.153931 Upright 3 with a 3/8 x 3 3/4 Bolt 122, a 3/8, Washer 91, and a 3/8 Nylon Jamnut

39.Route the Leg Lever Cable (75) under a 4 1/2” Pulley (119). Attach the Pulley and a Large Cable Trap (121) to the indicated side of the Butterfly

Upright (3) with a 3/8” x 3 3/4” Bolt (122), a 3/8”

Washer (91), and a 3/8” Nylon Jamnut (113).	Make
sure that the Large Cable Trap is turned to hold
the Cable in the groove of the Pulley.

40.Wrap the Leg Lever Cable (75) over a 3 1/2” Pulley

(78).Attach the Pulley to the Double “U”-bracket

(62)with a 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).

41.Remove the preattached 3 1/2” Pulley (not shown) from the “U”-bracket (64).

Attach the end of the Leg Lever Cable (75) to the “U”-bracket (64) with a 1/4” Washer (97) and a 1/4”

Nylon Locknut (34). Note: Do not completely tighten the Locknut; it should be threaded onto

the end of the Cable so that two threads show past the Locknut (see inset drawing).

42. Locate the Swivel Low Cable (72), which is the
only remaining cable that has an	eyelet on one
end and a ball on the other end.	Route the eyelet
end of the Cable through the cage on the Long
Base (120) and through the Swivel Upright (5) as
shown.

Attach a 3 1/2” Pulley (78) to the indicated bracket

on the Long Base (120) with 3/8” x 1 3/4” Bolt (93) and a 3/8” Nylon Locknut (87).

43.Wrap the Swivel Low Cable (72) under a 3 1/2” Pulley (78). Attach the Pulley to the indicated brack- et on the Long Base (120) with a 3/8” x 1 3/4” Bolt

(93)and a 3/8” Nylon Locknut (87).

16

39
	119
122
	121
	3
	75
	91	113
40
	93
	87
	62
	75
	78
41
64	75	75
	97
	34
		34
42
78
72
Cage	87
	120
93	5
43
	72
	78
120	87
93