Weider 831.159833 user manual

49.Wrap the Press Cable (72) under a 90mm Pulley (35). Attach the Pulley and a Cable Trap (38) to the indicated hole in the Press Upright (5) with an M10 x 93mm Bolt (85), an M10 Washer (97) and an M10 Nylon Locknut (90). Make sure the

Cable Trap is positioned to hold the Cable in the groove of the Pulley.

50.Route the Press Cable (72) through the opening in the Press Frame (17) and wrap the Cable around a 90mm Pulley (35) in the direction shown.

Attach the 90mm Pulley (35) and a Cable Trap

(38)to the indicated hole in the Press Frame (17) with an M10 x 81mm Bolt (104), an M10 Washer

(97)and an M10 Nylon Locknut (90). Make sure the Pulley is attached on the inside of the Press Frame. Make sure the Cable Trap is positioned to hold the Cable in the groove of the Pulley.

51.Wrap the Press Cable (72) around a “V”-pulley

(34)in the direction shown. Attach the “V”-pulley and a Long Cable Trap (37) to the small tube on the Press Upright (5) with an M10 x 81mm Bolt (104), an M10 Washer (97) and an M10 Nylon Locknut (90). Note: The small tube has four adjustment holes. The “V”-pulley must be attached at the hole farthest from the Upright. Make sure the Cable Trap is oriented as shown.

52.Wrap the Press Cable (72) around a 90mm Pulley (35) in the direction shown. Attach the Pulley and a Cable Trap (38) at the indicated hole in the Press Frame (17) with an M10 x 81mm Bolt (104), an M10 Washer (97), and an M10 Nylon Locknut (90). Make sure the Pulley is attached on the inside of the Press Frame. Make sure the Cable Trap is positioned to hold the Cable in the groove of the Pulley.

49
90
97		72
		35
	38	85
	5
50
72
90
35
38		97
	17	104
51	90
	97
	72
		5
	34	37
	104
52
104
72
97
38
35
90	17

20