Weider 831.159833 user manual Changing the Weight Setting

Page 26

CHANGING THE WEIGHT SETTING

To change the setting of a weight stack, insert a Weight Pin (81) under the desired Weight (41). Insert the Weight Pin so that the bent end touches the weight stack. Turn the bent end down.

To use the Bottom Weight (47) with the press arms or the leg press, insert a Weight Pin (81) under the Bottom Weight. Remove the other Weight Pin from the small weight stack.

To use the small weight stack with the press arms or leg press, insert a Weight Pin (81) under the Bottom Weight (47). Then, insert the other Weight Pin under the desired Weight (41) in the right weight stack.

 

41

 

41

81

47

 

Note: Due to the cables and pulleys, the amount of resistance at each exercise station may vary from the weight setting. Use the WEIGHT RESISTANCE CHART on page 27 to find the approximate amount of resistance at each weight station.

26

Page 25 Page 27
Image 26
Page 25 Page 27
Contents
Model No Serial No Sears, Roebuck and Co., Hoffman Estates, ILTable of Contents Important Precautions Before YOU Begin DecalAssembly Locate and open the parts bag labeled Frame AssemblyFrame Assembly Locknuts yetPage Tighten the Locknuts yet Onto the Bolts. Do not tighten the Locknuts yetLocknuts 86. Do not tighten the Locknuts yet Do not tighten the Locknuts yetPage Weight Guides 26. Note Make sure the Top It. Do not tighten the Locknuts yet Locknuts 90. Do not tighten the Locknuts yetNylon Locknut 90. Do not tighten the Locknut Arm Assembly AssemblyRepeat this step with the Left Butterfly Arm Cable AssemblyCable Assembly To the bracket on the back of the ButterflyRemove another V-pulley 34 from the bag Labeled Pulley BAG Identify the Rear Cable 70. It is approximatelyIdentify the Ab Cable 74. It is approximately Page Attached as shown Trap is positioned to hold the Cable Groove of the PulleyCable Guide 102 Remove the M10 Nylon Locknut 90 used in step Page Page Remove the M10 Nylon Locknut 90 used in step Attach the other Seat 23 to the Press Seat Seat AssemblyLocate and open the parts bag labeled Seat Frame 12, not shown in the same mannerPage Adjusting the LEG Press Plate AdjustmentsAttaching the Accessories Attaching the Curl PADChanging the Weight Setting Lbs Left Top Weight Resistance ChartWeight High Press LEG Butter LOW Pulley ARM FLY ARM Lever BottomPress Cable 72 can be tightened in the same manner Troubleshooting and MaintenanceTightening the Cables Page Press Cable 70, 95 1/8 71, 132 2/8 74, 226 1/2 72, 387 5/8 Cable DiagramsCable ID Chart Butterfly Cable Ab Cable Rear CableLow Cable Part Identification CHART-Model No .159833 R1203A Page Page Part LIST-Model No Qty Description159833 Full 90-DAY Warranty Sears, Roebuck and Co., Dept 817WA, Hoffman Estates, IL
Related manuals
Manual 37 pages 27.72 Kb