Weider 831.159833 user manual

Slack can be removed from the Press Cable (72) by moving the “V”-pulley (34) attached to the Press Seat Frame (12) closer to the Press Upright (5).

Remove the M10 x 93mm Bolt (85), M10 Washer (97), and M10 Nylon Locknut (90) from the Press Seat Frame (12), the “V”-pulley (34), and the Long Cable Trap (37). Move the “V”-pulley to a hole that is closer to the Press Upright (5), one hole at a time, until the slack is removed. Reattach the “V”-pulley and Cable Trap to the hole with the Bolt, Washer, and Locknut.

If there is still slack in the Press Cable (72), move the “V”-pulley (34) attached to the small tube on the Press Upright (5) to a hole that is closer to the Upright.

Remove the M10 x 69mm Bolt (92), M10 Washer (97), and M10 Nylon Locknut (90) from the Press Upright (5), the “V”-pulley (34), and the Long Cable Trap (37). Move the “V”-pulley to a hole that is closer to the Press Upright, one hole at a time, until the slack is removed. Reattach the “V”-pulley and Cable Trap to the hole with the Bolt, Washer, and Locknut.

	85
	97
12	37
	5
72	34
90
90
97
37
34
72	5
92

If a cable slips off the pulleys often, the cable may have become twisted. Remove the cable and re-install it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

29