Weider 831.159833 user manual Cable Assembly, Repeat this step with the Left Butterfly Arm

22. Identify the Right and Left Butterfly Arms (19, 20)	22	Bracket	7
by the positions of the welded brackets.
Press a 45mm Square Inner Cap (68) into each		Lubricate
end of the Right Butterfly Arm (19). Wet the lower		Axles
end of the Butterfly Arm with soapy water. Slide a				Welded
Large Foam Pad (53) onto the lower end of the				Brackets
Butterfly Arm.
Lubricate the axles on the Butterfly Top Frame (7)			68
with grease. Orient the Right Butterfly Arm (19)		19	54
as shown and slide it onto the right axle.
See the inset drawing. Place two 25mm			55
Retainers (54) on top of an inverted 25mm Cover			20
Cap (55). Make sure the teeth on the Retainers
bend toward the Cover Cap, as shown.		53
Have a second person gently tap the two 25mm
Retainers (54) and the 25mm Cover Cap (55)		68
onto the axle on the Butterfly Top Frame (7).
			Axle
Repeat this step with the Left Butterfly Arm
(20).			54
			Teeth
Cable Assembly				55
23. Locate and open the parts bag labeled	23
“CABLE ASSEMBLY.”
For cable identification and routing during
steps 23 to 61, refer to the CABLE DIAGRAMS				86
and CABLE ID CHART on pages 30 and 31.
Make sure that the cable traps do not touch or				Bracket
bind the cables as you assemble them.			20
Identify the Butterfly Cable (73). It is approxi-				73
mately 52” long and it has an eyelet on each end.
				84
Attach the Butterfly Cable to the bracket on the		Flat
Left Butterfly Arm (20) with an M8 x 20mm
Shoulder Bolt (84) and an M8 Nylon Locknut (86).		Side
Make sure that the flat side of the eyelet on	24
the cable (see the inset drawing) is against			37
theButterfly Arm.
24. Locate and open the parts bag labeled				34
“PULLEY BAG 2.” Remove one “V”-pulley (34)
from the bag.
			90
Wrap the Butterfly Cable (73) over the “V”-pulley			73	114
(34). Attach the “V”-pulley and a Long Cable Trap		4
(37) to the bracket on the back of the Butterfly
Upright (4) with an M10 x 58mm Bolt (114) and
an M10 Nylon Locknut (90). Make sure the Long
Cable Trap is oriented to hold the Cable in the
groove of the “V”-pulley.

13