Frame Assembly
1.Before beginning, be sure that you have read and understood the information on page 5.
Locate and open the parts bag labeled
“FRAME ASSEMBLY.”
Press a 50mm Square Inner Cap (67) into each end of the Butterfly Base (1).
Insert four M8 x 61mm Carriage Bolts (75) and an M10 x 89mm Carriage Bolt (95) up through the indicated holes in the Butterfly Base (1). Place the Butterfly Base flat on the floor. Note: If the Bolts fall out, secure them by putting a small piece of tape over the head of each Bolt.
2.Press three 50mm Square Inner Caps (67) into the Center Base (2). Insert an M10 x 89mm Carriage Bolt (95) up through the indicated hole in the Center Base.
Note: There are three kinds of support plates. The main difference between them is the dis- tance between the holes. When you need a support plate, find the kind with holes that will fit over the bolts you are using.
Attach the Center Base (2) to the Butterfly Base (1) with two M8 x 66mm Bolts (89), a Medium Support Plate (109), and two M8 Nylon Locknuts (86). Do not tighten the Locknuts yet.
3.Press a 50mm Square Inner Cap (67) into the end of the Press Base (3).
Insert four M8 x 61mm Carriage Bolts (75), an M10 x 63mm Carriage Bolt (76), and an M10 x 92mm Carriage Bolt (112) up through the indicat- ed holes in the Press Base (3).
Orient the Press Base (3) with the indents around the indicated holes on the bottom. Attach the Press Base to the Center Base (2) with two M8 x 66mm Bolts (89), a Medium Support Plate (109), and two M8 Nylon Locknuts (86). Do not tighten the
Locknuts yet.
6
1 |
|
|
|
|
|
|
|
|
|
| 67 |
| 1 |
|
|
| 95 |
|
|
|
|
| |
|
|
| 75 |
|
|
| 75 |
|
|
|
|
67 |
|
|
|
|
|
2 |
|
|
|
|
|
89 | 109 |
|
|
|
|
|
| 86 |
|
| 67 |
|
|
|
|
| |
1 | 86 | 2 |
|
|
|
|
| Hole |
|
|
|
|
|
| 95 |
|
|
3 |
|
|
|
|
|
|
|
|
| 86 | 67 |
| 2 |
|
|
| |
|
|
|
|
| |
|
| 86 |
|
| 109 |
| 3 |
|
|
|
|
|
|
|
|
| 89 |
|
| Indent | 75 | 76 | 112 |
|
|
| |||
| 75 |
|
|
|
|